V-Tac VT-8027 handleiding
Handleiding
Je bekijkt pagina 3 van 3
SENSOR DIAGRAM
CONNECTION-WIRE DIAGRAM
TEST
• Turn the TIME knob anti-clockwise on the minimum
(10s).Turn the LUX knob clockwise on the maximum
(sun).
• Switch on the power; the sensor and its connect-
ed lamp will have no signal at the beginning. Aer
Warm-up 30sec, the sensor can start work .If the sen-
sor receives the induction signal, the lamp will turn on.
While there is no another induction signal any more,
the load should stop working within 10sec±3sec and
the lamp would turn o.
NOTE: when testing in daylight, please turn LUX knob to (SUN) position, otherwise the sensor lamp
could not work! If the lamp is more than 60W, the distance between lamp and sensor should be
60cm at least.
The wires
come IN and
OUT from
bottom
The wires
come in and
out from the
side
Height of installation: 2.2-4m Detection Distance: Max 6m
• Turn LUX knob anti-clockwise on the minimum (3). If the ambient light is more than 3LUX, the
sensor would not work and the lamp stop working too. If the ambient light is less than 3LUX
(darkness), the sensor would work. Under no induction signal condition, the sensor should stop
working within 10sec±3sec.
Bekijk gratis de handleiding van V-Tac VT-8027, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | V-Tac |
| Model | VT-8027 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 683 MB |
Caratteristiche Prodotto
| Kleur van het product | Wit |
| Gewicht | 140 g |
| Breedte | 120 mm |
| Diepte | 35 mm |
| Hoogte | 124 mm |
