UniView IPC2228SE-DF40K-WL-I0 Handleiding (135 Pagina's)

Handleiding

33

Item Description

SNMP Type

Select

SNMPv2

. After you select SNMPv2, a message pops up to remind you of potential risks

and ask if you want to continue. Click

OK

.

Read Community

The default read community name is public, and you may change it as needed. Make sure the

read community names of the server and camera are the same, otherwise the two-way

authentication will fail.

Trap Server Address Set the trap server address in Management Server.

SNMP Port The default SNMP port number is 161. You may change it as needed.

Click Save.

5.2.8 802.1x

802.1x provides authentication to devices for access to the network and enhances network security by

allowing only authenticated devices to access.

Go to Setup > Network > 802.1x.

Enable 802.1x.

By default, the protocol is set to EAP-MD5. Select the same EAPOL version as that of the router or

the switch.

Enter the username and password for authentication.

Click Save.

5.2.9 QoS

QoS (Quality of Service) has the ability to guarantee the performance of high-priority services under

limited network capacity.

Go to Setup > Network > QoS.

Set a priority level (0 to 63) for each service.

Bekijk gratis de handleiding van UniView IPC2228SE-DF40K-WL-I0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.