Ufesa Ottawa handleiding

Handleiding

12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152/ 52

Afdrukken

Je bekijkt pagina 15 van 52

15

tential sources of danger.

• Before connecting the appliance, check that the voltage values shown on the data pla-

te correspond to those of the electricity supply network. In the event of incompatibility

between the electric outlet and the plug of the heater, have the outlet replaced with ano-

ther more suitable type by professionally qualified personnel, who will make sure that

the section of the wires of the outlet is appropriate for the absorbed power of the heater.

In general, the use of adapters or extension cords is not recommended; if their use is in-

dispensable, they must conform to existing safety standards and their current capacity

(amperes) must not be less that the maximum of the appliance.

• The power socket must be easy to reach so the plug can be removed quickly in case of

emergency.

• To not place the appliance near sinks or other container of liquids (minimum distance of

2 meters) to avoid the risk of it falling in.

• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obs-

truct the air intake grille; make sure that the front is free of unstable materials (dust, etc.).

• Make sure that the electric cord is not touching rough, hot or moving surfaces and not

twisted or wrapped around the appliance.

• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane

(the appliance could upset).

• In the event of a breakdown or poor operation, turn the fan off and ask for professionally

qualified help.

HOW TO ASSEMBLE (MONTREAL /OTTAWA)

1. Fix the Stand (12) into the Base (15) with the Tightening Screw (14) and Nut (16) provided.

2. Adjust the Stand (12) to the suitable height you desire.

3. Put the Motor (5) into the Stand (12) and tighten it with Knob Set (8).

4. Take off the Rear Guard Nut (3) off the Motor (5) and put the Rear Guard (4) into the Mo-

tor (5) and tighten it with the Rear Guard Nut (3).

5. Fix the Blade (2) into the Motor shaft.

6. Fix the Mark Plate (22) on the Front Guard (1) with the Mark Plate Screws (23).

7. Put the Front Guard (1) into the Rear Guard (4) and fix them together with the clip, buc-

kles and safety Fixing Screw (10) and Safety Fixing Nut (11).

HOW TO ASSEMBLE (OTTAWA 3 in 1)

1. For stand fan, its assembly is same as above.

Additional steps for Floor Fan:

2. Using Parts from Part 17,18,19,20,21 to make a full floor base.

3. Taking the head pre-assembled from the stand fan to fix on the floor base by using the

Knob Set (8), then it can be used as a floor fan.

4. To use as a wall fan is just to have the floor fan mounted onto the wall with the wall

brackets provided.

12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152/ 52

Bekijk gratis de handleiding van Ufesa Ottawa, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Caratteristiche Prodotto

Andere merken in Ventilator