True UNITE Touchscreen Console handleiding

Niet gecategoriseerd

True

36 pagina's

PDF beschikbaar

Handleiding

HOW TO ATTACH THE CONSOLE TO THE CONSOLE MAST

See the base assembly instructions for how to attach the console to the console mast for each cardio base.

Example of potential cable connections and instructions shown below.

A. If the console has three screws (00567700 // SCREW, M4-.7 X 12 PPHMS SEMS) preassembled, remove and set aside these

screws. They are not used in this installation. Remove and set aside the top two screws (00567800 // SCREW, M5-.8X12

COMBO PHILLIPS/COMMON TRUSS HEAD - ACG BLACK) preassembled to the console. Slightly loosen the bottom two

screws but leave them installed. All four screws will be used to secure the console to the mast in step C.

B. Connect the cables: network, coaxial, heart rate, safety key, I/O data, power, and ground (use the screw on the console

mast to attach the ground cable from the console).

NOTE: The LED console does not use the coaxial or network cables. Those cables can be tucked back down the console

mast.

Ensure all cables are routed inside the console mast to avoid pinching the cables

C. Using a #2 Phillips screwdriver, secure the console to the console mast using the four screws (00567800).

00567700

remove and

set aside these

screws, they are

not used in this

installation

00567800

I/O data

network

ground

coaxial

power

do not

connect

power here

heart

rate

button

control

ground

network

button control

ground

coaxial

power

heart rate

PVS power

I/O data

NOTE: Depending on the installation,

PVS power may not be used.

safety key

safety

key

EXAMPLE: ATTACH THE CONSOLE TO THE CONSOLE MAST

ASSEMBLY AND SETUP

Bekijk gratis de handleiding van True UNITE Touchscreen Console, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.