True TUC-67D-2-HC handleiding

30 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 10 van 30
9
TRUE
refrigerated prep
www
.truemfg.com
STARTUP
A. The compressor is ready to operate. Plug in the cooler.
B. Temperature controls are factory-set to give refrigerators
an approximate temperature of 35°F (1.6°C) and freezers
an approximate temperature of -1F (-23.3°C). Allow unit
to function several hours, completely cooling cabinet before
changing the control setting.
Temperature Control Location and Settings.
Electronic temperature control is located on rear of unit or
behind access grill.
LAE temperature control is located on the front of cabinet
countertop or in/behind louvered grill.
• Mechanical temperature control is located inside of unit.
See website for adjustments, sequence of operation, and more
information.
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your TRUE
dealer or recommended service agent.
D. Good air flow in your TRUE unit is critical. Be careful to
load product so that it neither presses against the back wall,
nor comes within four inches of the evaporator housing.
Refrigerated air off the coil must circulate down the back wall.
NOTE: If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION - Before loading product we recommend
you run your TRUE unit empty for two to three days. This allows you
to be sure electrical wiring and installation are correct and no ship-
ping damage has occurred. Remember, our factory warranty does not
cover product loss!
TPP REAR BUMPER INSTALLATION
KIT CONTENTS
Bumpers (2)
Screws (2)
TOOLS REQUIRED
Phillips Screwdriver
STEP 1
After removing cardboard crate, locate and remove bag of shelf clips
and bumpers that are secured to the box containing the castors.
STEP 2
Remove the cutting board from the back of the TPP.
STEP 3
Locate both pre-drilled holes in the back outer wall.
STEP 4
Remove 2 screws and 2 bumpers from the bag.
STEP 5
Install bumpers and screws with Phillips screwdriver.
1 2
3 4
5
OPERATION

Bekijk gratis de handleiding van True TUC-67D-2-HC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkTrue
ModelTUC-67D-2-HC
CategorieKoelkast
TaalNederlands
Grootte7032 MB