Handleiding
Je bekijkt pagina 13 van 22
EN 13
local air conditioner PAC-C 1500 S
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
• Check the power connection.
• Check the power cable and mains plug for damage. If you
notice damages, do not try to take the device back into
operation.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• Check the on-site fusing.
• Observe the operating temperature according to the
chapter Technical annex.
• If the device is not starting, have the electrics checked by
a specialist company or by the manufacturer.
The device works with reduced or no cooling capacity:
• Check whether cooling mode is selected.
• Check the position of the ventilation flap. The ventilation
flap must be opened to the maximum.
• Check the air filter(s) for dirt. If necessary, clean or replace
the air filter(s).
• Check the temperature setting at the device. Reduce the
set temperature if it is higher than the room temperature.
The device is loud or vibrates:
• Check whether the device is set up in a stable and upright
position.
Condensate is leaking:
• Check the device for leaks.
The compressor does not start:
• Check whether the overheating protection of the
compressor has tripped. Disconnect the device from the
mains and let it cool down for approx. 10minutes before
reconnecting it.
• The compressor may start up with a delay of 3minutes, as
it is provided with an internal protection against direct
restart.
The device gets very warm, is loud or is losing power:
• Check the air inlet and air filter for dirt. Remove external
dirt.
• From the outside, check the device for dirt (see chapter
Maintenance). If the inside of the device is dirty, have it
cleaned by a specialist company for cooling and air-
conditioning or by the manufacturer.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to a specialist company for cooling and air-conditioning
or to the manufacturer for repair.
Error codes
In case of a fault, an error code is indicated on the segment
display(25). Contact the customer service in case of the
following faults.
Error code Fault description Possible cause/
troubleshooting
FL
Condensate
reservoir in the
external unit is
full
Remove the stopper on the
rear of the device and drain
the condensate.
E1 and E2
Room
temperature
sensor errors
Have the room temperature
sensor replaced by the
customer service.
EF
Motor fault in the
internal unit
Have the motor replaced by
the customer service.
Eb
Lack of
refrigerant
Please contact the customer
service.
E4
Defrost function
active
Check the air outlet. Remove
potential blockages.
Bekijk gratis de handleiding van Trotec PAC-C 1500 S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Trotec |
| Model | PAC-C 1500 S |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 2784 MB |
