Handleiding
Je bekijkt pagina 6 van 20
5A - CLEANING THE CONDENSER (cont’d):
Vacuum or brush any dirt, lint or dust from the nned
condenser coil, the compressor and other cooling system
parts. If signicant dirt is clogging the condenser ns,
use compressed air to blow this clear. Care should be
taken not to bend any of the condenser ns, as this will
reduce performance and compressor life. Lower louver
assembly and replace screws to hold it in place.
5B - HINGE REPLACEMENT:
To remove the door, remove the plug at the bottom of the
top hinge. Behind this is a screw which secures the door
in place. Remove this with a at head screwdriver and
then lift the door off the hinge. To remove the door portion
of the hinge, lift off the hinge cover and then remove the
3 Phillips head screws which secure the hinge in place.
To remove the cabinet portion of the hinge, remove the 3
Phillips head screws which hold it in place. On solid door
units, the top hinge(s) contains a switch for controlling the
lights.To reassemble the hinge reverse the procedure.
5C - REPLACING THE GASKETS:
To remove the gasket to be replaced, grasp it rmly by
one corner and pull it out. Before attempting to install a
new gasket, both the unit and gasket must be at room
temperature. Insert the four corners rst by using a rub-
ber mallet (or hammer with a block of wood). After the
corners are properly inserted, work your way towards the
center from both ends by gently hitting with a mallet until
the gasket is completely seated in place (see gure 7 for
proper gasket placement).
4C - LIGHT SWITCHES:
All G-Series models include a concealed door switch mounted in
the top door hinge(s), which automatically activates the interior
light when the door is opened. When the door is closed, the lights
are not operating.
In addition, on hinged glass door models, an exterior mounted,
illuminated red switch is included for manual light control. In the
ON position, the lights are illuminated whether the doors are open
or not. In the OFF position, the lights are controlled by the hinge
switch as described in the rst paragraph.’
4D - TURN OFF TEMPERATURE DISPLAY-MAIN DISPLAY
SHORT CUT: There is a short cut to disable the external tempera-
ture display. Note that before doing so you must install an interior
mounted thermometer in order to conform with local health codes.
• Press the Unlock Key twice
within a second in order to unlock
the keypad (think “tap-tap”).
• The Keypad Unlock LED will
turn on to indicate the keypad
is now live.
• Press and hold the Unlock Key for 3 seconds until the
temperature display goes blank.
To restore the temperature display, press any key except the
Unlock Key:
• Press the Unlock Key twice within a second in order to unlock
the keypad (think “tap-tap”).
• The Keypad Unlock LED will turn on to indicate the keypad is
now live.
• Press any key except the Unlock Key to restore the
temperature display.
5. CARE & MAINTENANCE
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY
BEFORE CLEANING ANY PARTS OF THE UNIT.
5A - CLEANING THE CONDENSER:
The most important thing you can do to insure a long, reliable ser-
vice life for your Traulsen is to regularly clean the condenser coil.
The condensing unit requires regularly scheduled cleaning to
keep the nned condenser clean of lint and dust accumulation.
Keeping the condenser clean allows the cabinet to operate more
efciently and use less energy. To clean the condenser, rst
disconnect electrical power to the cabinet and lift up the front
louver assembly. To lift this, remove the two screws located on
both sides at the bottom of the louver assembly (see gure 5).
Once the screws are removed, the panel can be pivoted upwards
allowing full access to the front facing condenser (see gure 6).
5. CARE & MAINTENANCE (cont’d)
4. OPERATION (cont’d)
Fig. 7
Fig. 6
Lift-Up Louver
Assembly
Fig. 5
Remove
Screws
NOTE: The gasket may
appear too large, but if it
is installed as indicated
above it will slip into
place.
G SERIES
Page 5
DISPLAY
SYMBOL
DISPLAY
DESCRIPTION
Unlock Key
Keypad Unlock
LED
Bekijk gratis de handleiding van Traulsen G21010-032, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Traulsen |
| Model | G21010-032 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 3471 MB |
