Trade-Wind VSL448022BF handleiding
Handleiding
Je bekijkt pagina 4 van 10
Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 4
Important Cut-out Information
Cabinet or hood cutouts should be at least
1
/
8
‖ larger than the following outside dimensions
Models Available (by Width)
Pic
CFM
28
3
/
8
”
34
3
/
8
”
40
3
/
8
”
46
3
/
8
”
52
3
/
8
”
58
3
/
8
”
Sones
Control
Blower
A
-
VSL430BF
VSL436BF
VSL442BF
VSL448BF
VSL454BF
VSL460BF
N/A
Variable
In-Line or Remote
Mount Blower
PART 2 Securing the Liner
TILE BACKSPLASHES
IMPORTANT: Liners installed immediately above the top edge of tile backsplashes thicker than
3
/
4
‖ should be
installed slightly forward—not flush with the back wall. The back filter bracket of the liner is 1‖ deep and tile
installations thicker than this will prevent the filters from being removable.
MOUNTING HOLES
NOTE: DRILLING THROUGH STAINLESS STEEL REQUIRES A TITANIUM BIT. BE CAREFUL NOT TO DRILL
THROUGH FILTER BRACKETS, ELECTRICAL COMPONENTS OR UL LABEL.
Because the Trade-Wind
®
Standard Series Liner was designed for various wood hood applications, no mounting
holes have been pre-drilled. This allows the liner to be attached in most any area of the canopy that has a wood
frame support, e.g., the back, sides or top. We recommend at least six equally spaced screws per liner—three
screws along the back (top or back side panel) and three screws on the front top, immediately next to the light bar
wall or behind the removable light bar. Where possible, the screw holes should be drilled into the top of the liner
(instead of the sides or back). This will help prevent distorting the liner walls in situations where the wood frame is
not properly sized to the liner. Models with internal motors should also have at least one screw centered and
securely in place on each end (side panel) of the liner because of the added weight.
Neatly measure and mark (left to right and top to bottom) and drill screw holes through the liner as required to
match the wood backing. It is easier to drill holes from the outside in, by setting the liner on its face (on cardboard)
and drilling from the back side. Secure the liner by driving screws (by others) tightly into the wood frame. Use
washers where necessary. When removing the filters, be careful not to scratch the liner by placing the filters,
screws, drill bits or drill on the liner’s face.
Notes:
1. Center of electrical access is 7‖ from front & 2
1
/
2
‖ from side of liner.
Connection access is behind filters.
2. Vent is 8‖ (models 430 & 436) or 10‖ (442, 448, 454, & 460).
Damper not included.
3. Length & width cutouts should be
1
/
8
‖ larger than above
dimensions.
A
Bekijk gratis de handleiding van Trade-Wind VSL448022BF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Trade-Wind |
| Model | VSL448022BF |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 1961 MB |
