Handleiding
Je bekijkt pagina 19 van 21
19
TEMPORARY OPERATION
12
In case of the misplaced or discharged remote controller.
• Pressing the RESET button, the unit can start or stop without using
the remote control.
• Operation mode is set on AUTOMATIC operation, preset temperature
is 24°C and fan operation is automatic speed.
AUTO RESTART FUNCTION SETTING
13
This product is designed so that, after a power failure, it can restart
automatically in the same operating mode as before the power failure.
INFORMATION
The product is shipped with Auto Restart function in the ON position.
Turn it OFF if this function is not required.
How to turn OFF the Auto Restart Function
• Press and hold the [RESET] button on the indoor unit for 3 seconds
(3 beep sounds but OPERATION lamp does not blink).
How to turn ON the Auto Restart Function
• Press and hold the [RESET] button on the indoor unit for 3 seconds
(3 beep sounds and OPERATION lamp blink 5 time/sec for 5 seconds).
NOTE
• In case of ON timer or OFF timer are set, AUTO RESTART OPERATION
does not activate.
SELF CLEANING OPERATION
(COOL AND DRY OPERATION ONLY)
14
To protect bad smell caused by the humidity in the indoor unit.
1. If the
button is pressed once during “Cool” or “Dry”
mode, the fan will continue to run for other 30 minutes, then it will
turn off automatically. This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the
more 2 times
within 30 seconds.
OPERATION AND PERFORMANCE
15
1. Three-minute protection feature: To prevent the unit from being
activated for 3 minutes when suddenly restarted or switched to ON.
2. Some minor cracking sound may occur when unit operating.
This is normal because the cracking sound may be caused by
expansion/contraction of plastic.
Air conditioner operating conditions
Temp.
Operation
Outdoor Temperature Room Temperature
Cooling –10°C ~ 46°C 21°C ~ 32°C
Dry –10°C ~ 46°C 17°C ~ 32°C
ECO OPERATION
9
To automatically control room temperature to save energy
(except in DRY and FAN ONLY mode)
Press
: Start and stop the operation.
NOTE
• Cooling operation; the set temperature will increase automatically
1 degree/hour for 2 hours (maximum 2 degrees increase).
TIMER OPERATION
10
Set the timer when the air conditioner is operating.
Setting the OFF timer
1
Press for enter OFF timer setting.
2
Press for select desired OFF timer. (0.5 - 12 hrs)
3
Press for set OFF timer.
4
Press again for cancel OFF timer.
DISPLAY LAMP BRIGHTNESS ADJUSTMENT
11
To decrease the display lamp brightness or turn it off.
1. Press and hold
for 3 seconds until brightness level
(
, , or ) is shown on remote control LCD then release
the button.
2. Press
Rise
or
Decrease
to adjust brightness
in 4 levels.
Remote control
LCD
Operation display Brightness
100%
Lamp illuminates full brightness.
50%
Lamp illuminates 50% brightness.
50%
Lamp illuminates 50% brightness and the
operation lamp is turned off.
All turned off
All lamps are turned off.
• In the examples of and , the lamp illuminates for 5 seconds
before going off.
RESET Button
Bekijk gratis de handleiding van Toshiba RAS-H10B2ACV2G-M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toshiba |
| Model | RAS-H10B2ACV2G-M |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 2542 MB |
