Toro 58355 handleiding
Handleiding
Je bekijkt pagina 54 van 99
2. Install the heat shield and mounting screw to
muffler body. Make sure the holes in the
heat shield align with mounting holes in muf-
fler body.
Torque the screw 15-25 in•lb (1.7-2.8 N•m).
3. For Models 280, 300BV, 310, And 310BV
Blowers And Blower/Vacs— Install the lower
plate of heat shield to the main part of
shield. Secure the lower plate with 4 screw
Remove Clutch
Some units are equipped with a clutch. If no clutch
exists proceed to “Remove Starter Housing.”
1. Remove the four screws securing the clutch
cover to starter housing. Remove the clutch
cover.
NOTE: Early models used Loctite® to secure
the screw in the clutch drum. It may be difficult
to remove these screws, use a hardened screw-
driver, or screwdriver bit with a clean and sharp
blade.
Units with serial number 71200438 and greater
use a #T20 Torx® head screw to secure the
clutch drum.
2. Install flywheel holder, P/N 612470.
3. Using the appropriate screwdriver or screw-
driver bit, loosen screw inside of the clutch
drum.
Remove the clutch drum.
DISASSEMBLE MAJOR
COMPONENTS (cont.)
2.6089.060
2.6089.055
2.6089.056
3
DISASSEMBLY, INSPECTION, & REPAIR
3-29
Bekijk gratis de handleiding van Toro 58355, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toro |
| Model | 58355 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 35687 MB |
