Tornado VCRMCWC handleiding
Handleiding
Je bekijkt pagina 13 van 115
English 13
the water tank and blocking the outlet pipe.
- Filling with hot water is prohibited, which otherwise may
lead to deformation of the water tank.
- Reinstall the dust box and water tank combo module
Mop installation
- Wring out the fully soaked mop until no water drops are
present. Place the mop bracket on the reverse side, insert
the mop pad along the mop bracket slot. Then, affix the
mop securely.
Install the mopping module
- Push the mopping module with the mop pad installed in
parallel along the back of the Robot Vacuum, and install it
in place when a “click” sound is heard.
Start cleaning
- The mopping function is activated when starting cleaning
task.
Remove the mopping module
- After Robot cleaning, press the pause key, and press the
bottons on both sides and take out the mopping module
backwards.
- After the Robot completes mopping, please remove the
mop combo module and cleaning mop in a timely manner
during charging or out of service, and also drain the water
tank to avoid odor or mildew.
Note : - Do not use the mopping function if the Robot is left
unattended.
- Do not leave the wet mopping combo module at an area
for a long time, which otherwise may lead to floor damage
due to exposure to over-moisture.
- The Robot using the moping combo module may operate
at a less capability in overcoming the hurdle height. Thus,
operators shall closely check for any jamming.
- The mopping function is only applicable to the clean floor
without stubborn stains or liquid. If there are coffee stains,
ink stains and other colored stains on the floor, do not use
the mopping function to avoid floor contamination.
- The mopping function acts ideally on smooth and hard
floors, and it may not work well on uneven tiles, floors
covered with a lot of wax or rough surfaces. Under such
circumstances, the Robot may not successfully complete
mopping as it may be jammed or slided.
- It is prohibited to mop on the blanket.
- For the purpose of optimum mopping effect, it is advised
to clean the floor with Robot 3 times before mopping.
- Water flow rate adjustment
- For the purpose of optimum mopping effect, users may
set any water flow level on a case-by-case basis.
- The higher the water flow level, the less time in
completing mopping at one time.
- Closely check for water makeup for optimum mopping
effect.
Vacuuming Function
1. Remove the vacuuming module
- Remove the vacuuming module from the charging base
using its handle.
2. Connection and removal of the hose assembly
- Press the button on the hose assembly connector to connect
it to the detachable vacuuming module, and then install the
crevice nozzle on the other side of the connector hose.
- When the vacuuming task is finished or there is a
need for auto-empty dirt, disconnect the hose assembly
connector by pressing the button on it, and store the hose
properly for future use.
3. Start/Pause
- The detachable vacuuming module can be activated
by pressing the Start/Pause button after being removed.
When not in use, it can be paused by the Start/Pause
button and then placed back to the base.
4. Suction Level Adjustment
- Different levels are available to suit your specific needs
using the suction level button. To switch from Level 3
Bekijk gratis de handleiding van Tornado VCRMCWC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tornado |
| Model | VCRMCWC |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 17004 MB |
