Toolson DWS225R handleiding
Handleiding
Je bekijkt pagina 25 van 232
GB
|
25
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: V-belts, abrasives, worm gears, carbon
brushes, pulleys
* Not necessarily included in the scope of delivery!
Storage
m Important! Pull out the mains plug!
1. Whenever you do not use the power tool, you
must keep it in a dry and well ventilated place out
of the reach of children, e.g. on a high cabinet or
in a closed place.
2. Keep power tool, instruction manual and acces-
sory parts, if any, together in the original packag-
ing, if possible. Thus you have all information and
parts available at any time.
10. Transport
m Important! Pull out the mains plug!
1. Always hold the power tool by its handle.
2. To avoid transport damages, you must pack the
power tool or use the original packaging.
3. Protect the power tool against vibrations and
shock, especially during transport in vehicles.
11. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
The printing of the type designation on the connec-
tion cable is mandatory.
AC motor
• The mains voltage must be 220 - 240 V~ 50 Hz.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
2
.
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
9. Cleaning, maintenance and storage
m Important!
Pull out the power plug before doing any cleaning and
maintenance work on the equipment. Risk of injury
from electric shock!
m Important!
Wait until the equipment has cooled down complete-
ly! Risk of burns!
Cleaning
• Keep the equipment free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or
blow it down with compressed air at low pressure.
• We recommend that you clean the equipment im-
mediately after you use it.
• Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plastic
parts in the equipment. Ensure that no water can
get into the interior of the equipment.
Maintenance
Check the power tool and accessory parts (e.g. inser-
tion tools) for wear and damage before and after each
operation. lf necessary, replace worn out or damaged
parts with new parts and make sure to comply with
the operating instructions. Observe any technical re-
quirements.
Replacing the sanding plate on the round sand-
ing head.
If the round viscid disc is damaged in the work, a new
viscid disc can be purchased from our company for
replacement. Remove the sandpaper, put the Allen
wrench into the hexagon hole in the center of the
viscid disc and then rotate to take o the damaged
viscid disc. Install the new viscid disc.
Bekijk gratis de handleiding van Toolson DWS225R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toolson |
| Model | DWS225R |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 31672 MB |
