Tognana Iridea D2DFU01IR handleiding
Handleiding
Je bekijkt pagina 17 van 80
17
3. Place the glass carafe (3) on its base and turn it clockwise to secure it.
4. Place the carafe assembly on the base, turning it clockwise.
5. Insert the ingredients in the carafe, making sure not to exceed the maximum capacity, and secure the lid
(2) on the carafe by pressing it down.
6. Insert the dosing cap (1) in the opening in the lid and turn it clockwise until it clicks in.
7. Check that the ON-OFF control is set to “0”.
8. Place the carafe assembly (9) on the motor body (8) and turn it clockwise until it clicks in.
9. After use, carry out the procedure in reverse to disassemble the appliance.
SAFETY SYSTEM
This appliance has two safety devices, one on the lid and one on the blade assembly.
The appliance only works if the carafe assembly is properly inserted on the motor body and if the lid is properly
inserted on the carafe.
If the glass and lid are removed, the appliance turns off.
OPERATING PRINCIPLE
1. After assembling the appliance, place it on a horizontal and stable surface far from sources of heat.
2. Connect the appliance to a power socket.
3. Turn the blender on:
o Speed 1: for low-density foods
o Speed 2: for very consistent foods
o P: to blend ice and for short, powerful impulsive movements. The switch is not permanently activated
in the “P” setting. The switch must be held in the “P” setting or repeatedly turned.
4. At the end of processing, always return the switch to position “0”.
5. Disconnect the appliance from the power socket.
6. Turn the carafe assembly counter-clockwise to remove the carafe.
7. Do not use the appliance for more than 3 minutes continuously. Allow a 1-minute pause between
processing cycles.
HELPFUL ADVICE AND TIPS
• For a more consistent mix, we recommend adding the solid ingredients into the carafe in small pieces (2-
3 cm) a little at a time, using the dosing cap.
• When mixing solid ingredients, start with a small amount of liquid first. Gradually add more liquid through
the opening in the lid.
• Always put your hand on top of the blender when using the device.
• Exercise caution when processing hot liquids.
• Remove any nuts from fruit before processing.
• To blend solid or very dense liquid ingredients, it is recommended to use the blender in pulse mode.
• To blend ice and to process consistent products, use the “P” pulse function.
CLEANING AND MAINTENANCE
Before cleaning, always disconnect the blender from the power socket and leave it to completely cool.
1. Cleaning the carafe
To clean the blades between processing cycles, fill the carafe halfway with water, place it back on the
motor body and set the switch to “P” a few times.
After processing, for thorough cleaning wash the carafe, the blade assembly and the lid with warm water
and dishwashing detergent, or in the dishwasher at a maximum temperature of 55°C.
HAZARD! Exercise caution when handling the chopping blade.
Bekijk gratis de handleiding van Tognana Iridea D2DFU01IR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tognana |
| Model | Iridea D2DFU01IR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9830 MB |
