Toa TS-D1000-EX handleiding
Handleiding
Je bekijkt pagina 9 van 44
9
[Rear]
28 29
31
32
33
30
35
27
34 36
37
27. Cable clamp
Route the power cable through this clamp to
prevent the AC adapter plug from accidentally
being disconnected.
28. Signal ground terminal
When connection of an external device to the TS-
D1000-MU results in the generation of audible
noise, connect this terminal to the Signal ground
terminal of the external device. Noise output
should be greatly reduced.
Note
This is not a protective ground connection.
29. DC inl et
Insert the power plug from the unit’s supplied AC
adapter into this inlet.
30. Conference unit connection terminal
RJ45 x 2
Connects to the Conference unit by way of a
Cat5e STP LAN cable. Up to 16 conference units
can be daisy chain connected to each terminals.
31. Sub control unit connection terminal
RJ45
Connects to a maximum of 5 Sub-Control units by
way of a Cat5e STP LAN cable. If 5 Sub-Control
units are connected, up to 246 Conference units
can be connected to the system.
32. Network connection terminal
RJ45
Connects the PC to the network by way of a Cat5e
STP LAN cable.
• 10 BASE-T/100BASE-TX indicator (Orange)
Extinguishes when a 10BASE-T network is
connected to the TS-D1000-MU, and lights
when a 100BASE-TX network is connected.
• LINK/ACT indicator (Green)
Lights when the TS-D1000-MU is connected to
a network and ashes during data transmission/
reception.
33. Recording output terminals
(−10 dB*, 10 kΩ, unbalanced, RCA pin jack x 2)
Connect to external recording devices, such as
IC recorders. The same sound output is delivered
to both jacks so that simultaneous recordings can
be made using two recording devices.
34. Line output terminal
(−10 dB*, 10 kΩ, unbalanced, phone jack)
Connects to a PA amplier or other public address
device.
35. Equalizer connection terminals
(−10 dB*, 10 kΩ, unbalanced, RCA pin jack x 2)
Connect to an external processor, such as a
feedback suppressor (FBS). Depending on the
status of the input and output terminals, sound
routing and internal FBS ON/OFF status are
automatically switched.
[When connected to an external processor]
When an external processor is connected to
these SEND and RETURN terminals, the internal
FBS circuit is switched OFF.
[When not connected to an external processor]
When no external processor is connected to
these SEND and RETURN terminals, the internal
FBS circuit remains ON.
36. Video conference system connection terminals
(−10 dB*, 10 kΩ, unbalanced, RCA pin jack x 2)
Connect to external devices such as a video
conference system. Mix-minus function eliminates
unit-generated signals from the output.
37. Microphone input terminal
(−54 dB*, 600 Ω, unbalanced, phone jack)
Connects to a wired microphone.
* 0 dB = 1 V
LINK/ACT indicator
10BASE-T/
100BASE-TX indicator
Bekijk gratis de handleiding van Toa TS-D1000-EX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toa |
| Model | TS-D1000-EX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4300 MB |
