Handleiding
Je bekijkt pagina 16 van 24
16
Step 6. Install the safely wire to the wall.
Install the end of the safety wire attached
to the speaker to the anchor bolt installed
on the wall surface.
Step 7. Connect the speaker cable to the input terminal.
For the connection procedure, refer to p. 8, "Input Terminal Connection."
Nut and washers
(required separately)
M10 safety wire anchor bolt
Safety wire
Speaker
Step 4. Screw 2 supplied hex bolts loosely to the speaker.
Follow the same installation procedure to the other side.
Step 5. Mount the speaker to the mounting brackets.
Mount the speaker in the way that the Mounting Brackets A and B secured to the wall are inserted
into the slits in the speaker's rear panel.
About 5 – 7 mm (0.2" – 0.28")
Fix the hex bolt loosely leaving about 5 – 7 mm
(0.2" – 0.28") protruding.
Hex bolt M8 x 40
(accessory)
Loosely fitted hex bolt
Mounting Bracket A
Mounting Bracket A
Mounting Bracket B
Note
In this event, check to be sure that the
loosely fitted bolts are inserted fully into
the notches in the Mounting Bracket until
they will not go any further.
Mount the speaker in the way that
the Mounting Bracket is inserted into
the slits in the speaker's rear panel.
Bekijk gratis de handleiding van Toa SR-PB5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toa |
| Model | SR-PB5 |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 2288 MB |
