Toa SOB-1 handleiding
Handleiding
Je bekijkt pagina 2 van 4

2 TOA Electronics Europe GmbH d
■ OPENING OF THE SWITCH-OVER BOX
You can pull off the top cover by depressing lightly on
both sides at the place indicated in the drawing. This
will loosen the catches.
■ CLOSING OF THE SWITCH-OVER BOX
Push the top cover onto the top of the housing. Take
care that
- the grooves mesh with each other,
- the snaps are on inner side and
- the top cover snaps in audible.
■ MECHANICAL CABLE FIXING
The switch-over box is equipped with
3 cable inlets:
two for max. 9 mm and one for max.
13.5 mm cable diameter.
1. Turn off the thread joint and
remove all parts inside the flange.
Remark: the sealing washer will
not be used in the further steps.
2. Push the parts thread joint, ring
and rubber ring in this order onto the cable (refer also to the drawing). Push these
parts close together and let the cable’s end have a length of 20 - 30 cm.
3. Push the cable into the flange until the parts touch the flange’s inner end.
4. Fasten the thread joint by turning clockwise.
snaps
Thread Joint
Metal Ring
Flange
Rubber Ring
Sealing Washer
Bekijk gratis de handleiding van Toa SOB-1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Toa |
Model | SOB-1 |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 558 MB |