Handleiding
Je bekijkt pagina 18 van 24
18
Step 5. Adjust the vertical angle by gradually loosening the
angle adjustment bolt of the speaker bracket.
• The speaker bracket is divided into part A and part
B, which are secured with the angle adjustment bolt.
The vertical angle is adjusted in the interlocking
section of the parts A and B.
Note
Never remove the angle adjustment bolt or loosen
it too much so that the parts A and B come o.
• For the angle adjustment range, see "Range of
Speaker Installation Angle" on p. 10.
• Be sure to perform installation work while supporting
the speaker with one hand.
Step 6. Tighten the angle adjustment bolt.
Recommended tightening torque: 2 N·m
Note
Check that the parts A and B of the speaker bracket are rmly engaged.
Step 7. Connect the speaker cable to the input terminal. (See p. 7.)
Step 8. Secure the speaker bracket to the base bracket by rmly tightening the ange nut temporarily tightened
in Step 4-2.
[Recommended tightening torque]
F-03BT, F-03WT, F-05BT, F-05WT: 10 N·m
F-08BT, F-08WT: 20 N·m
Step 9. Adjust the horizontal angle by moving the base bracket as shown
in the gure at right.
For the angle adjustment range, see "Range of Speaker
Installation Angle" on p. 10.
Step 10. Firmly tighten the nuts temporarily tightened in Step 1 to secure
the base bracket to the ceiling.
Recommended tightening torque: 10 N·m
Step 11. Attach the supplied base bracket cover to the base bracket using
the supplied screw.
Recommended tightening torque: 1 N·m
Put the wiring cable into the base bracket cover taking care not to apply excessive force.
Ceiling Ceiling
Brand mark
Brand mark
Base bracket cover
Base bracket cover
Machine screw
M4 x 8*
Machine screw
M4 x 8*
[Vertical installation] [Horizontal installation]
* with plain washer and spring washer, accessory
Tip
The brand mark is attached to the speaker’s front grille with the double-sided adhesive tape.
You can change the orientation of the brand mark, if needed. In this case, peel o the brand mark slowly
and carefully, then you can reattach it after changing its orientation.
5, 6
The figure represents the horizontal installation.
Angle adjustment
bolt
Ceiling
Part A
Part B
Speaker bracket
(Side view)
Ceiling
Base bracket
9
Bekijk gratis de handleiding van Toa F-08WT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toa |
| Model | F-08WT |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 2992 MB |
