Thor H-THUNDER-4 handleiding
Handleiding
Je bekijkt pagina 9 van 24
H-THUNDER-4
Tel:(800)521‐8467Email:sales@thorfiber.comhttp://www.thorbroadcast.com
2.2 General Settings
After powering on the device, it will show the device IP address. When you press the OK key, the main interface has 6 menus and sub-menus,
press the up and down keys to switch the options, press the OK key to enter the specified sub-menu to modify the parameters.
2.2.1 TS Config
The H-THUNDER-4 outputs up to 4 RF modulation carriers. Under this menu you can enter the corresponding channels
(1-4) to set your relevant parameters. Select each channel and set your settings as you see fit.
Channel 1/2/3/4
The H-THUNDER-4 also has can output any standard DVB-C, DVB-T, ATSC or ISDB-T modulation. Select different modulation
standards under the modulate menu, the TS parameters will be different with each standard.
Main
1 TS Config
2 Encode
3 Modulate
4 Network
5 System
Settings
6 Soft Version
6 Soft Version
5 System Setting
4 Network
4.1 IP Address
4.2 Subnet Mask
4.3 Gateway
5.1 Save & Reboot
5.2 Restore
5.3 Factory set
6.1 Web Version
6.2 Board ID
6.3 Board Version
6.4 Core version
TS Config
Channel 1
Bekijk gratis de handleiding van Thor H-THUNDER-4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Thor |
| Model | H-THUNDER-4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6550 MB |
