Handleiding
Je bekijkt pagina 28 van 96
en-us Troubleshooting
28
Troubleshooting
17 Troubleshooting
Troubleshooting
You can eliminate minor issues on your appliance
yourself. Please read the information on eliminating issues
before contacting Customer Service. This may avoid
unnecessary repair costs.
WARNING
Improper repairs are dangerous.
▶ Repairs to the appliance should only be performed by
authorized service providers.
▶ Only original spare parts may be used to repair the
appliance.
▶ If the power cord or the appliance power cable of this
appliance becomes damaged, it must be replaced with
a special power cord or special appliance power cable,
which is available from the manufacturer or the
manufacturer's Customer Service.
Issue Cause and troubleshooting
The appliance is not cooling, the
displays and lighting are lit.
Showroom mode is switched on.
1. Press and hold ALARMOFF for 15 seconds until three audible signals sound.
a The lighting on the control panels and the interior lighting switch themselves off
briefly.
a "ALARMOFF" flashes and a warning signal sounds.
2. Press ALARM OFF.
3. After a short time, check whether your appliance is cooling.
The LED lighting does not work. Various causes are possible.
▶ Call customer service.
→
"Customer Service", Page31
HomeConnect® is not working
properly.
Various causes are possible.
▶ Go to www.home-connect.com.
"E" or "d" appears on the
temperature display.
The electronics have detected a fault.
1.
Switch off the appliance. →
Page14
2. Disconnect the appliance from the power supply.
Unplug the power plug or switch off the circuit breaker in the fuse box.
3. Reconnect the appliance after 5 minutes.
4.
Switch on the appliance. →
Page14
5. If the message still appears on the display, call customer service.
→
"Customer Service", Page31
A warning signal sounds and
"ALARMOFF" flashes.
The door alarm is switched on.
The appliance door is open.
▶ Close the appliance door.
A warning tone sounds and the
temperature display (freezer
compartment) and "ALARMOFF"
flash.
The temperature alarm is switched
on.
Various causes are possible.
1. Press ALARM OFF.
a The alarm is switched off.
2. After several hours, check whether the set freezer compartment temperature has
been reached again.
External ventilation openings are covered up.
▶ Remove any obstructions from in front of the external ventilation openings.
Large quantities of fresh food have been placed inside.
▶ Switch on Super freezing before placing a larger amount of food in the appliance.
→
"Switching on Super freezing", Page15
Bekijk gratis de handleiding van Thermador T36FL810NS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Thermador |
| Model | T36FL810NS |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 15194 MB |