Thames & Kosmos Ultra Bionic Blaster handleiding

Niet gecategoriseerd

Thames & Kosmos

24 pagina's

PDF beschikbaar

Handleiding

Rotate subassembly C so that

the light gray side faces out.

Side view

Align gears exactly as shown.

Rotate the cap

counterclockwise

to lock.

Fasten, but do not tighten

the screws all the way.

B13 x3

Turn the axle to so that

the line in the center is

vertical and aligned as

shown.

Place the gear E1 so that the line is on the bottom,

vertical, and aligned as shown.

1. Push the slider all

the way down.

2. Place subassembly C.

3. Place C4.

4. Rotate C4 counter-

clockwise to lock.

Make sure E8 is

pulled out all the way

while assembling.

Apply oil to the teeth of

subassembly A on both sides.

Front view

The slots on

the bottom

of E7 slide

along

these

tracks.

1. Apply oil to the top and bottom of the

two E7 parts as shown.

2. Slide the tracks (E7) all the way in

(see image below).

3. Then place the tracks down so that

their teeth mesh with the gears below.

Place the

neck of E19

into the

semi-circular

notch as

shown.

E19

Fasten, but do not

tighten the screws

all the way.

B13 x3

Top

Bottom

Make sure there is no gap

at all between E7 and the

purple rail on both sides.

Even a small gap here will

cause a malfunction.

IMPORTANT!

Make sure the

green sliders are

pushed down and

the trigger is

pulled out.

Assembling the Ultra Bionic Blaster

After installing subassemblies A, B, and C,

test the trigger.

> When the trigger is at rest, both green

sliders should be all the way down, and

there should be no gap between the

trigger and the handle.

> Now squeeze the trigger. The motion

should be smooth, and the trigger should

spring back easily.

If you have problems with any

of these checks, go back to

step 57 or watch this video:

Bekijk gratis de handleiding van Thames & Kosmos Ultra Bionic Blaster, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.