Thames & Kosmos TrainBots handleiding
Handleiding
Je bekijkt pagina 5 van 48
OPERATING TIPS
3
Battery Module
1. Keep the circuit board dry. Avoid coming into
contact with moisture.
2. Do not connect the battery
module cable to the circuit board
while the circuit board is
accessible (Wait until the model
is closed). It can be dangerous.
3. Do not touch the circuit board
when it is powered on.
1. Only handle your TrainBots model
with dry hands. Do not handle it
with wet hands.
2. TrainBots is not a toy for the bathtub
or pool.
Only use the enclosed pipette
(P14) for filling the water tank.
Be careful not to overfill the
tank; if it overflows, the circuit
board may become damaged.
Make sure there is water in the tank
before powering on your TrainBots
model.
When handling your robot, lift it by the
battery pack on its back, and make sure
to keep it upright to avoid spillage.
When adjusting the angle of the
chimney, only move it as far as
shown in the picture below.
Otherwise, the model could break.
Do not touch the
ultrasonic atomizer
when the chimney
is open.
Only fill the water tank
with water. Scented
oils and any other
types of liquids will
damage it.
Make sure the chimney
is open when you are
filling the tank. Do not
pour water into the
closed chimney.
Do not touch the pressure
gauge needle while your
TrainBots model is powered
on. This could damage it.
Do not cover the chimney with
your fingers or obstruct it
with other objects. This could
prevent the mist from
escaping and cause moisture
to pool around the atomizer. If
this occurs, you can find
troubleshooting instructions
on page 44.
Battery module
TrainBots
Bekijk gratis de handleiding van Thames & Kosmos TrainBots, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Thames & Kosmos |
| Model | TrainBots |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25912 MB |
