Thames & Kosmos Pepper Mint in the Fantastic Underwater Science Voyage handleiding

36 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 16 van 36
1
Tub
2 x syringes
30-cm
tube
YOU NEED …
You will also need: ruler, scissors, tap
water, adhesive tape, paper towels
HERE’S HOW!
1
Remove the mast and the cabin. Turn your
ship upside-down.
Use the scissors to cut a 30-cm length of
tube, with a straight edge at the end, and
then connect this tube to a syringe.
Completely fill the tube and syringe with tap
water, as described on page 9.
Insert the tube full of water through
one of
the portholes in the side panel, then
insert it
down again through the hole in the base
panel of the ship, as shown. Have a towel
ready in case the tube leaks.
2
Slide an empty syringe (the plunger should
be pushed all the way down) into the big
hole in the base panel of the ship. The
handles on either side of the syringe should
be touching the underside of the base panel,
while the barrel of the syringe should be
pushed down through to the other side.
3
Turn the ship the right way up again. Connect
the open end of the tube to the empty syringe.
3
Tip!
You can seal the open end of the tube
with a piece of adhesive tape, so that
it doesn’t drip during assembly.
13
Rocking Waves
and the

Bekijk gratis de handleiding van Thames & Kosmos Pepper Mint in the Fantastic Underwater Science Voyage, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkThames & Kosmos
ModelPepper Mint in the Fantastic Underwater Science Voyage
CategorieNiet gecategoriseerd
TaalNederlands
Grootte24761 MB