Thames & Kosmos Flip-Flop Bead Party handleiding

Niet gecategoriseerd

Thames & Kosmos

20 pagina's

PDF beschikbaar

Handleiding

You will need:

Extra foam material, yellow cord,

needle, 2 buttons, ruler, pencil,

scissors

Here’s how:

Cut two rectangular pieces out

of the leftover foam material.

Ideally, mark them first using a

ruler and pencil before cutting.

They should be about 1.5 cm long

and 1 cm wide. These will

become the pieces that go

between your toes. Set them

upright on the marked spot near

the front tip of each sole cutout.

Now cut a length of cord about

50 cm in length and thread it

through your needle. Push the

needle lengthwise through the

toe piece you just cut, and then

through the point you marked

on the sole. Pull the cord

halfway through the sole.

Next, you will need a button,

which you will thread onto the

end of the cord coming out the

bottom part of the sole. The best

way to do it is to untie the cord

from the needle and draw the

thread carefully through the two

button holes, as shown in the

illustration to the right. The

button will ensure that the cord

doesn’t rip through the foam

material later on when you’re

walking.

The piece that goes

between your toes

Bekijk gratis de handleiding van Thames & Kosmos Flip-Flop Bead Party, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.