Texas Premium 4831TR handleiding
Handleiding
Je bekijkt pagina 43 van 52
Troubleshooting
If your problem is not described above, please contact an approved service centre or Texas A/S.
Difficult to start
Problem Cause Solution
Generally difficult to start
•
Wrong starting procedure
•
Follow the starting instructions in the manual precisely.
The start cable is very tight (will not start)
• The brake handle is not being activated
• The machine is placed in high grass
• Activate the brake handle and pull the start cord.
• Move the machine away from the high grass and repeat the start procedure.
Set the height adjustment in the highest position, so that the blade is lifted free of
the grass.
The machine will not start when the start cord
is pulled
•
The brake handle is not being activated
• The wires are not connected to battery
The brake cable is incorrectly adjusted
• The machine is standing in high grass
• Engine is not primed before starting
• The choke is not in the correct position
• No more gasoline in fuel tank
• The gasoline is more than 3 months old
•
Activate the engine brake handle and press the electric start button.
• Check that the wires are connected from the battery to the motor and start button.
• Adjust the engine brake cable, following the instructions in the manual.
• Move the machine away from the high grass to start it.
Tip the machine when starting.
Set the height adjustment in the highest position, so that the blade can run freely.
• Push the primer 1-3 times before starting.
• Move the choke lever to a different position.
• Check and fill fuel tank with gasoline.
•
Empty the fuel tank and carburetto
r
from old gasoline, and fill with new gasoline.
No ignition spark (cannot start)
•
The spark plug cap is loose
• The spark plug is damp or dirty
• Incorrect gap between the spark plug
and the electrode
•
The air filter is dirty or defective
•
Check that the cap is firmly attached to the spark plug.
• Check that there is no dirt on the spark plug, following the instructions in the
manual.
• Check and adjust the spark plug gap, following the instructions in the manual.
Aalternatively, replace the spark plug.
•
Check the air filter for dirt and clean it, following the instructions in the manual.
The mower starts, but runs unevenly
Problem Cause Solution
The front wheels are not pulling, or only very
little
• The clutch cable is too tight/too loose
• The ratchets in the rear wheels are worn
•
Rem has fallen off / is damaged
• Adjust the clutch cable, following the instructions in the manual.
• Replace the ratchets.
•
Inspect belt, replace if necessary
The engine runs irregularly and/or its
performance becomes poor as you are
working
• The spark plug cap is loose
• The spark plug is dirty
• Incorrect gap between the spark plug
and the electrode
• The air filter is dirty or defective
• Evaporation of fuel in the carburettor
• Loose throttle cable
•
Dirt in the carburetto
r
• Check that the cap is firmly attached to the spark plug.
• Check that the spark plug is clean and not damaged, following the instructions in
the manual.
• Check and adjust the spark plug gap, following the instructions in the manual.
• Check the air filter for dirt and clean it, following the instructions in the manual.
• Wait a few minutes, and then try to start again.
• Tighten the throttle cable, following the instructions in the manual.
•
Clean the carburetto
r
.
The en
g
ine will not stop
Problem Cause Solution
The machine does not stop after 5 seconds
•
The engine brake cable runs too tightly
•
Check and adjust the engine brake cable, following the instructions in the manual.
Bekijk gratis de handleiding van Texas Premium 4831TR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Texas |
| Model | Premium 4831TR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8936 MB |
