Texas MDS40-33-4 handleiding
Handleiding
Je bekijkt pagina 16 van 40
16
4. Battery
GTX4000 is delivered with both battery and charger.
Warning: Do not try to disassemble, short circuit or put it to extreme heat or fire, as it can
cause serious inquiry and permanent damage to the battery!
Charging
• Only use the original charger with art. no. 90066658 (standard charger) or 90066657
(quick charger).
• Before the battery is being used the first time, it is recommended to full charge it first.
The battery has an energy indicator. Press the button and a number of LED lighs will
flash (Illustration 7):
• 4 lights: 100% battery power
• 3 lights: 75% battery power
• 2 lights: 50% battery power
• 1 lights: Less than 25% battery power
Note: The indicator lighs is only indicative indications, and is not accurate power
indications.
Important: To protect the battery from total discharge, the machine will stop, when the
battery is nearly empty.
The machine must not be started up again after automatic shutdown, as it can damage
the battery. The battery must be recharges before the work can continue.
5. Charging
A full charge takes around 75 min (2.5Ah battery).
Only use the original charger, which is included with the product and do not try to charge
other type of batteries in the charger, other than the original battery with art. no. 90066660
(2.5Ah) or 90066659 (4.0Ah).
• Keep the charger in a dry and warm environment (10-25 degrees C) and only use it
indoor. It should be connected to a normal 230V AC socket.
• Before the battery is being used the first time, it is recommended to charge it fully.
• The surface of the battery can become warm during charging. This is normal.
• Do not cover battery or charger during charging. Allow free ventilation of air.
Insert the battery into the slots of the charger and slide it into place until it locks.
There are 4 lights on the charger indicating the status and state of charge of the battery
• Constant red light: The charger is ready to charge, but no battery is connected
• Flashing red light: Battery fault or overheat (always let a warm battery cool off before
charging it)
• Flashing green light: Battery is charging
• Constant green light: Batteri er fuldt oplades og skal fjernes fra opladeren.
Important: The charger will stop, when the battery is full. However, it is not
recommended to leave the battery in charger for more than 24 hours.
Bekijk gratis de handleiding van Texas MDS40-33-4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Texas |
| Model | MDS40-33-4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6670 MB |
