Testboy TV 910 handleiding
Handleiding
Je bekijkt pagina 12 van 52
Operation
12 Testboy
®
TV 900
Operation
Thank you for deciding on the Testboy
®
TV 910, an EVSE (Electric Vehicle Supply Equipment) adapter.
This test adapter is an accessory for additional Testboy measuring instruments and testers, for example, to carry out safety or func-
tion tests using an installation tester. It has a type 2 connector for testing charge accessories for electric vehicles (EVSE Mode 3).
The solid housing of the Testboy
®
TV 910 means that it can also be used under harsh operating conditions.
The Testboy TV 910's LED display is intended as a guide value rather than a reading.
For this, suitable measuring/test equipment should be used!
Safety information
You have chosen an instrument providing a high degree of safety. To ensure safe and correct application, it is necessary to fully
read this operating manual before using the instrument for the first time.
1) Type 2 connector
2) Phase indicator
3) Banana jacks for phases L1, L2, L3
4) Banana jack for PE
5) CP-State rotary switch
6) Phase rotary switch
7) CP-State E (Fault Simulation) button
8) Socket
9) Banana jack for N
10) PP-State rotary switch
11) PE Fault Simulation button
The following safety precautions apply:
| If the display fails to indicate one or more functions,
then do not continue to use the instrument. It must
be checked by a specialist.
| Avoid contact with the banana jacks (3, 4, 5, 11)!
(Refer to the figure)
| The instrument must not be operated in a humid en-
vironment!
| Always keep the instrument dry and clean. The
housing should only be cleaned using a damp cloth.
| The various signals displayed by the voltage tester
should not be used for measurement purposes.
Function
The instrument simulates a connected electric vehicle and enables various charge states to be simulated. The TV 910 has various
measuring and tapping points. To switch on the instrument, connect the type 2 connector to a charge column. When the charge
column is enabled, the LEDs indicate the phase(s). The “CP-State” (Control Pilot Resistance) rotary switch can be used to simulate
various charge states. The banana jacks enable testing using various test leads. Additional measuring instruments can be con-
nected to the socket. The phases can be switched with the relevant rotary switch. The “PP-State” (Proximity Pilot Resistance)
switch can be used to simulate a cable (N.C., 13 A, 20 A, 32 A, 63 A are selectable).
The “CP-State E” and “PE Fault Simulation” buttons can be used to simulate fault states. E.g. a PE conductor break.
WARNING
The socket has a maximum load capacity of 5 A! It is also important not to switch between phases under load!
Bekijk gratis de handleiding van Testboy TV 910, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Testboy |
| Model | TV 910 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4321 MB |
