Televés T.0X TWIN 5806 handleiding
Handleiding
Je bekijkt pagina 14 van 32
Twin Modulator
14
5.1. Main Menu
From here on, scroll down to see the dierent
submenus by pressing the key
: Output Menu,
Channel Table Menu, Video Menu, Audio Menu and
Audio Mode Menu.
Note: If you wish to change the menu language , the
“Language” menu should be accessed before
con guring the device. This is done by holding
down the
key in order to access the Extended
menu, pressing the key three times and then
pressing or to select language. Finally,
hold down the key to record changes. For
more information, see “Extended Menu =>
Select Language” section ”.
To switch between A and B modules of the
TWIN unit, keep pressed the key until the A/B
indication stars to ash in the upper left corner
of the display.Then use keys and to select de
desired module.
5. - Instructions for use
The unit sends its con gured parameters
(frequencies/output channels, output levels, audio
and video con guration, FW version,...) to the
programmer when they are connected each other.
Upon initiating the process, the SW version of the
programmer will be displayed for a few seconds
with the following screen:
Next, the programmer’s display will show the
loaded FW version for a few seconds:
After this, the main menu is displayed.
a. Output Menu
Allows to select the module to be con gured and
its output channel, both in channel mode and in
frequency mode, and indicates the output level.
The way it is displayed will depend on how the
module has been programmed since its last con-
guration (frequency mode or channel mode).
If the device is in channel mode, then this
menu displays the number and frequency of the
output channel’s video carrier (which varies upon
changing the channel); it also displays digits
(00-99) allowing control of the corresponding
modulator’s output level via the programmer. To
select one of the modulators (A or B) of the TWIN
unit, press the key once, then the A/B indication
will ash. Next, use keys or to make the A or
B selection.
To change the output channel of the chosen
modulator, move through the menu by pressing
the parameter selection key until the channel
value stars to ash. Then use keys and to
change it.
For example, if the selected channel is C21 of the
CCIR UHF table:
Bekijk gratis de handleiding van Televés T.0X TWIN 5806, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Televés |
| Model | T.0X TWIN 5806 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2582 MB |
