Televés T.0X 564301 handleiding

36 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 15 van 36
EN
15
5.1 Standard menu
5.1.a Input menu
The multiplexer consists of 3 demodulator
(called A, B and C in the menus). The signal to
be demodulated comes from one of the two
F connectors, since the second input can be
congured either as a loop-through of the rst
one, or as an independent input (see menu 5.2b).
In the latter case, demodulator A receives signal
from connector 1 while demodulator B and C
receive signal from the second connector. The
module is able to provide power voltage to 2 LNB
through their input connectors whenever they
are congured as independent inputs, as well as a
selection of satellite using DISEqC commands.
The rst standard menu allows to select the input
frequency and the symbol rate of each one of the
3 input channels.
















To modify the frequency, press until the desired
parameter starts to ash. Then change its value
using keys and .
The range of allowed input frequency values is
950-2150 MHz, whereas the range for symbol rate
is 2 to 45 Mbaud. Detection of both DVB-S2 and
5 Instructions for use
Connect the programming unit to the front socket
of the module (“PRGM”).
At rst, the controller’s rmware version will
appear:




Next, it is displayed the rmware version of the
corresponding module:








DVB-S signals is automatic.
These parameters will be active when the option
“Enabled” is selected
These parameters are only operational when
you select the option ‘Enabled’. If you switch
from ‘Enabled’ to ‘Disabled’ the input will not be
considered.
Whenever the selected input is locked it will be
shown a symbol on the right of the Input eld , as
follows:
















In the event of a “short circuit” in the input
connector (LNB power enabled on any of both
inputs), a LED on the front of the module will ash
until the condition disappears.
5.1.b QAM modulation menu (only
to the Ref. 564401)
The following main menu allows selecting, for each
of the two outputs, the parameters of output QAM
modulation:

Bekijk gratis de handleiding van Televés T.0X 564301, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkTelevés
ModelT.0X 564301
CategorieNiet gecategoriseerd
TaalNederlands
Grootte3938 MB