Teka SHS 100 handleiding
Handleiding
Je bekijkt pagina 39 van 48
From "5"&"6" , customer could know heating status . The light "5" will turnon when
power is connected. The light “6“ will flash when smart controlenergy saving mode
is started. According the temperature setted, thelight “5" will be shown in red which
means water heater is being heated.When inner water heater temperature reaches
the setted value , light “5"will be shown in white, which means water heater enter
into warm-keepingstatus.
"4" could show the current inner water temperature as well as settedtemperature
value.If no person operates on water heater , the value indisplay screen " 4" means
current temperature value .By spinning knob"3" , "4" values will vary accordingly (
i.e temperature setting process) ,when finish temperature setting , "4" values will
return back to actual currentinner water heater temperatrue
If number " 3" comes out , it means smart control energy saving mode, the water
temperature is automatically changed. The appliance works to reduce the electrici-
ty energy of the user consumption, which allows heat loss to be minimized and
energy savings to be maximized.
This function is manually activated, The user can press the MODE button three
time at 0 AM local time to start the smart control function and calibrate the time and
hot water usage;
If number " 4" comes out , it means ECO mode,, the temperature is set to 55℃ and
cannot be adjusted ;
If number " 5"
comes out , it means a high temperature sterilization mode, the fixed
setting temperature is 80 degrees, and heating starts when the temperature is
lower than this temperature. The heating temperature will keep 80 degrees, for 5
minutes , then exit the bacteriostasis and return to the default mode ;
If number " 6" comes out , it means the reservation mode. Function introduction:
when the mode is selected as 6, the digital tube above the display will light up as
"6". The system enters the appointment hour setting mode, the digital screen
displays the appointment hour time, the setting range is 2-23, the knob adjusts the
setting time, and enters the appointment mode after flashing for three seconds, at
this time the knob can set the temperature, the appointment is to exit two hours in
advance and heat up .
1.
2.
3.
The supply socket must be earthed reliably. The rated current of the socket
shall not be lower than 10A. The socket and plug shall be kept dry to
prevent electric leakage. Inspect frequently whether the plugs are well
plugged in the socket. Inspect method is as follows: insert the power
supply plug into the socket,after using for half an hour, shut down the unit
and pull the plug out, and inspect the plug in case it scalds your hand. If
tempeature is over 50℃, please plug in another socket. to avoid the plug
being damaged, fire or other personnel accidents result from badcontact.
For the places or the wall where the water
may splash, the installation
height of the socket shall not be lower than 1.8m.
The wall in which the electric water heater is installed shall be able to bear
the weight equalling twice the weight of the heater fully filled with water
without distortion or cracks. Otherwise, other strengthening measures
should be adopted.
7
Bekijk gratis de handleiding van Teka SHS 100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Teka |
| Model | SHS 100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5373 MB |
Caratteristiche Prodotto
| Soort bediening | Draaiknop |
| Kleur van het product | Wit |
| Ingebouwd display | Ja |
| Gewicht | 38380 g |
| Breedte | 570 mm |
