Handleiding
Je bekijkt pagina 17 van 75
15
EN
Troubleshooting
TROUBLESHOOTING
The following simple issues can be handled by the user. Please call the after-sale
service department if the issues are not solved.
Problem Possible Causes Solution
Not operate
• The power supply is not turned on and
the plug is not firmly inserted.
• Low voltage, power failure or part of
the circuit tripped.
• Insert the power cord plug firmly.
• Check the power supply at home.
Light not on
• The appliance is not powered on.
• The light is broken.
• Unplug and re-plug the power cord.
• Replace the light with a new one.
Fruits or vegetables
are frozen
• Has the food been placed at the back
of the fridge? The area near the back
wall is where the temperatures are
coldest.
• Fruits or vegetables are stored in the
Fresh/Chill zone.
• Not placing food which may freeze
easily at the back of the fridge
compartment.
• The Fresh/Chill zone is only for meat/
fish.
Fridge/freezer is over-
cooling
• Temperature control is not set
correctly.
• Set the temperature higher.
Compressor working
for a long time
• High ambient temperature causing
long working time.
• Putting too much food in at one time.
• Food is put in before it has cooled
down.
• Opening the door too often.
• The frost layer inside is too thick.
• This is normal.
• Do not put too much food in at one
time.
• Wait until the food has cooled down
before putting it in.
• Do not open the door too often.
• Need to defrost.
Door does not close
properly
• Door is stuck with objects.
• Too much food in.
• Door gasket deformed.
• Do not put in too much food.
• Place the appliance stably.
• Heat the door gasket, then cool it for
restoration (with an electrical drier or
hot water for heating).
Outer wall is hot
• When the appliance is operating, heat
is dissipated to the outside through the
metal tubes inside the cabinet.
• Higher ambient temperatures in the
summer cause the temperature of the
outer wall to rise.
• Higher temperature on the outer wall
is normal.
• Increase the heat dissipation space, or
put the appliance in a ventilated and
cool place.
Cross or vertical
beams are hot
• There are metal tubes inside the
beams, and the heat released from the
tubes prevents condensation.
• This is normal.
Odors
• Spoiled food
• Food with strong odors
• The interior compartment is dirty.
• Clean and remove any spoiled food.
• Make sure strong smelling food is
wrapped airtight.
• Clean the interior compartment.
The actual
temperature
differs from the set
temperature
• When warm food is put in, the
temperature will rise temporarily.
• After setting a new temperature, it will
take some time for the temperature
in the compartment to reach the set
temperature when the door is not
opened.
• After the temperature stability, the
actual temperatures at different
locations within the compartment are
different, with a deviation of about
±3°C.
• This is normal.
• Wait for some time before testing the
actual temperature.
Bekijk gratis de handleiding van Teka RBF 44630 WH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Teka |
| Model | RBF 44630 WH |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 9564 MB |
