Teka EX 60.1 3G AI AL DR CI LPG handleiding

Fornuis

Teka

68 pagina's

PDF beschikbaar

Handleiding

ADJUSTMENTS AND CONVERSIONS

Always disconnect the appliance from the

electricity main before making any

adjustments.

All seals must be replaced by the technician at

the end of any adjustments or regulations.

Our burners do not require primary air

adjustment.

11) TAPS

“Reduced rate” adjustment

- Switch on the burner and turn the relative knob

to the “Reduced rate” position (small flame

fig. 1).

- Remove knob “M” (fig. 12 and 12/A) of the tap,

which is simply pressed on to its rod. The by-

pass for minimal rate regulation can be: beside

the tap (fig. 12) or inside the shaft. In any case,

to access to regulation, it can be done trought

the insertion of a small screwdriver ‘’D’’ beside

the tap (fig. 12) or in the hole ‘’C’’ inside the shaft

of the tap (fig 12/A). Turn the throttle screw to the

right or left until the burner flame has been

adequately regulated to the “Reduced rate”

position.

The flame should not be too low: the lowest small

flame should be continuous and steady. Re-

assemble the several components.

It is understood that only burners operating

with G20 gas should be subjected to the above

mentioned adjustments. The screw must be

fully locked when the burners operate with G30

or G31 gas (turn clockwise).

12) REPLACING THE INJECTORS

The burners can be adapted to different types of gas by

installing injectors suited to the type of gas required. To

do this, first remove the burner tops using a wrench “B”.

Now unscrew injector “A” (see fig. 13) and fit a injector

corresponding to the type of gas required.

It is advisable to tighten the injector in place.

After the injectors have been replaced, the burners

must be regulated as explained in paragraphs 11.

The technician must reset any seals on the

regulating or pre-regulating devices and affix the

label corresponding to the new gas regulation on

the appliance instead of the already existing one.

This label is supplied in the packet containing the

spare injectors.

The envelope with the injectors and the labels can

be included in the kit, or at disposal to the

authorized Customer Care Department.

For the sake of convenience, the nominal rate chart also

lists the heat inputs of the burners, the diameter of the

injectors and the working pressures of the various types

of gas.

TAPS LUBRIFICATION

Should a tap being blocked,

do not force and ask for

Technical Assistance.

Bekijk gratis de handleiding van Teka EX 60.1 3G AI AL DR CI LPG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.