Handleiding
Je bekijkt pagina 19 van 44
CLEANING / INSTALLATION
19
CAUTION: before cleaning of any kind,
disconnect the appliance from the mains.
2) COOKING SURFACE
To maintain the surface of the barbecue always
clean and to extend the lifespan of the appliance,
it is very important to wash it after every use with
warm, soapy water, rinse, and dry thoroughly.
Let the barbecue and all its parts cool off before
cleaning. Do not use scouring pads, abrasive
cleaners or corrosive sprays.
Never allow vinegar, coffee, milk, salt water,
lemon or tomato juice to remain in contact with the
surfaces for long periods of time.
WARNING!
- To maintain the grill in good condition after
use, it should be treated with the special
products available on the market so that the
surface always remains clean. This
procedure is necessary to prevent the
formation of rust.
- Don’t use steam jets for the equipment
cleaning.
- When cleaning the grill, do not raise the
heating element beyond the first block.
When finished cleaning, replace the heating
element in its original horizontal position.
TECHNICAL DATA
FOR INSTALLERS
Installation and maintenance listed in this
section must only be carried out by qualified
personnel.
The appliance must be correctly installed in
conformity with current law and the
manufacturer's instructions.
A faulty installation can cause damage to
persons, animals or objects, towards whom
the manufacturer cannot be held responsible.
The cut-off or automatic control devices of the
appliance can only be modified by the
manufacturer or by a duly authorized supplier.
3) INSTALLING THE BARBECUE
Take the barbecue out of its packaging, unpack
the various loose parts, then make sure it is not
damaged. In case of doubt do not use the
appliance and contact a qualified technician.
Packaging (cardboard, bags, expanded
polystyrene, nails...) must not be left within
children's reach as they are potential sources
of danger.
An opening in the table top of the piece of modular
furniture must be made with the dimensions
indicated in fig. 1, making sure that the dimensions
of the space required to install the appliance are
observed (see fig. 2).
This is a Class 3 appliance and is therefore
subject to all the requirements set by the
standards for these appliances.
4) SECURING THE BARBECUE
To secure the barbecue to the worktop the
fastening clamps accompanying this booklet must
be assembled. The following procedures must be
carried out to do this:
remove all movable parts from the barbecue;
turn the appliance over taking care to place it on
a soft surface to avoid damaging the external
surfaces;
remove the clamps "G" from the package and
install them according to the diagram in fig. 4.
After these steps have been carried out, the
special gasket that prevents liquids from leaking
can be installed. To fit this gasket correctly, please
strictly follow the directions below:
- detach the gasket strips from their support taking
care that the transparent protection remains
attached to the gasket.
- Put the gasket "E" (fig. 4) in the correct position
under the edge of the table top, so that the outer
side of the gasket fits perfectly with the external
perimeter of the worktop. The ends of the strips
must fit without overlapping.
- Make sure the gasket adheres to the countertop
evenly all around, press it down with your
fingers, then remove the protective strip of the
gasket and position the barbecue in the opening
made in the worktop.
- Secure the appliance by tightening the clamp
screws "F" (see fig. 5).
- In order to prevent any accidental contact with
the surface of the heated barbecue during use, a
separation in wood must be inserted and
fastened with screws at a minimum distance of
60 mm from the top (fig. 6).
WARNING!
Note that the adhesive which joins the plastic
laminate to the worktop must be resistant to
temperatures of no less than 150 °C to prevent
the covering from detaching.
The installer is advised that the rear wall,
adjoining and surrounding surfaces of the
barbecue must be resistant to a temperature
of 90 °C.
WARNING: MAINTENANCE MUST
ONLY BE PERFORMED BY
AUTHORIZED PERSONS.
Bekijk gratis de handleiding van Teka EFX 30.1 BBQ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Teka |
| Model | EFX 30.1 BBQ |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5709 MB |
Caratteristiche Prodotto
| Apparaatplaatsing | Ingebouwd |
| Soort bediening | Draaiknop |
| Kleur van het product | Roestvrijstaal |
| Ingebouwd display | Nee |
| Gewicht | 8420 g |
