Teesa TSA5018 handleiding
Handleiding
Je bekijkt pagina 6 van 15
10
11Owner’s manual Owner’s manual
ENEN
VACUUM ACCESSORIES*
Dustbin with HEPA lter, at nozzle with brush
Installation: Unscrew the cap from the air inlet. Attach the vacuuming nozzle and
rotate it until it locks in place.
NOTE: When vacuuming nozzle is not used, make sure to attach the cap to the air inlet.
CHARGING
* Vacuuming nozzle TSA-AKC80 is sold separately. It is not included in set!
It is available for purchase online at www.teesa.pl or www.rebelelectro.com.
1. Connect the USB-C plug of the included charging cable to the USB-C socket on
the handle of the device.
2. Connect the other plug to the compatible AC charger and to the power outlet or
a PC USB port.
3. Charging starts automatically.
4. During charging, the battery indicator ashes:
5. When the battery is fully charged, the battery indicator stops ashing and shows:
Note: If the device turns o automatically during use, it means that the battery level is low and the device
requires charging.
1. Press and hold the ON/OFF button for about 3 seconds
to turn on the device. It starts on the rst airow level.
The indicator is as follows:
2. Press the ON/OFF button again to switch to the
second airow level:
3. Press the ON/OFF button for the third time to switch to
the third airow level:
OPERATION
4. Press the ON/OFF button again to switch to standby mode. The airow level
indicators ash. The device will automatically turn o after 1 minute of no
operation. All indicators go o.
5. Press and hold the ON/OFF button for about 3 seconds to turn o the device.
6. When the device is on, press and hold the LED light button for about 3 seconds to
turn on the LED light. Press and hold again to turn it o.
Note: To reduce battery consumption, the light will turn o automatically when used for more than
40 minutes.
CLEANING AND MAINTENANCE
• Prior to cleaning make sure the device is o.
• Clean the device’s body with a dry and soft cloth.
• Clean the nozzles with a soft cloth or rinse them under running water. Make sure
to dry it completely before reassembly.
• Vacuuming nozzle*:
• Remove the HEPA lter from the dust container. Gently tap out dirt and
remove any hair, debris or threads which may have entangled around the
lter. HEPA lter is washable. If heavily soiled, rinse it under running water.
After rinsing let it air dry completely in the shade.
• Empty the dust container after each use. Then clean it with a soft cloth or
rinse it under running water. Afterwards, let it dry completely.
NOTE It is strictly forbidden to install slightly wet parts into the appliance, especially
the HEPA lter as this brings the risk of electric shock and can damage the appliance.
Bekijk gratis de handleiding van Teesa TSA5018, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Teesa |
| Model | TSA5018 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 1470 MB |
