Handleiding
Je bekijkt pagina 7 van 23
12 13Owner’s manual
EN EN
Owner’s manual
CHARGING
Fully charge the appliance before rst use.
1. Open the rubber plug at the bottom of the blender’s motor unit.
2. Connect the included micro USB cable to the micro USB port at the bottom of the motor unit.
Connect the other plug to the AC adapter and to the wall outlet or a compatible PC USB port.
3. During charging red LED is on.
4. When the battery is fully charged, blue LED is on.
5. Disconnect the blender from power supply and close the rubber plug tightly.
Notes:
• Charging takes approximately 4 hours.
• It is not possible to turn on the appliance during charging.
• When red LED lights up during use and the appliance stops, that means that the battery
level is low and the appliance must be charged immediately.
OPERATION
Before rst use: Wash all the parts that will have contact with food. Rinse them thoroughly with warm
water and allow to air dry. Never submerge the motor unit in water or any other liquid!
1. Place the motor unit on a at and stable surface.
2. Properly prepare the food to be processed. Peel it, remove seeds if necessary and cut it
into small pieces.
3. Put the food in the cup then add liquid (e.g. milk, water, juice). Do not exceed the MAX line.
For proper operation, the cup should be lled in 80% maximally.
Notes:
• Red LED ashes and the blender does not start if the cup is overlled.
• Never start the appliance if liquid is not added to the cup.
4. Flip the motor unit upside down and install it on the cup. Proper assembly is indicated by
the LED ashing red and blue once quickly.
Note: The appliance has a protection against accidental switch on. If the cup is not
installed on the motor unit or is installed improperly, the appliance will not turn on.
5. With the blender ipped upside down (so that the blades can start with no load), tap the
ON/OFF touch button twice to turn on the blender (blue LED is on).
Note: If during operation or when starting the blender, red LED ashes and the appliance
stops, that means that the protection has been activated. It may be because the pulp get
stuck in blades. Make sure to start the blender as described above.
6. After starting, ip it back to its starting position. Then shake the blender left and right.
Note: The appliance stops in less than 30 seconds after start-up and the blue LED ashes
what means that the cup is empty or the load is too light.
Main features
6 stainless steel blades
Level indicator with scale
Anti-slip rubber ridge
BPA free
Protections: overheat, overcurrent, overload
Technical data
Speed: 17000 rpm
Cup capacity: 450 ml
Used materials:
Motor unit housing: ABS
Blades: stainless steel
Cup: borosilicate glass
Charging port: micro USB
Charging time: approx. 4 h
Battery: 2x 2000 mAh
Power: 100 W
Power supply: 5 V / 1 A
Set includes: cap, micro USB cable
Physical parameters
Dimensions: Ø 82x226 mm
Weight: 580 g
SPECIFICATION
CLEANING AND MAINTENANCE
• Remove the cup from the motor unit by turning it anticlockwise.
• Rinse the cup under running water or wash it in a dishwasher. Let it dry completely.
• Wipe the motor unit with a soft, slightly wet cloth or rinse it under running water.
• Do not immerse the motor unit in water or any other liquid!
• To clean the blades, you can pour some warm water with mild detergent into the cup,
then attach motor unit and run one blending cycle. Repeat until the blades are clean.
• After cleaning let the all the parts air dry.
7. The blender will run for approximately 30 seconds and then automatically stop*. You can
stop blending earlier, by pressing the ON/OFF touch button once.
* The appliance may be used continuously about 4 times. Afterwards, stop the appliance
and let it cool down for about 10 minutes.
8. When blending is nished, detach the motor unit from the cup by turning it anticlockwise.
Bekijk gratis de handleiding van Teesa TSA3543, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Teesa |
| Model | TSA3543 |
| Categorie | Blender |
| Taal | Nederlands |
| Grootte | 2526 MB |
