Teesa Sweeper 7000 TSA5040 handleiding
Handleiding
Je bekijkt pagina 10 van 25
SAFETY INSTRUCTIONS
Thank you for purchasing TEESA appliance. Read this instruction manual and keep it for future
reference. Producer does not take responsibility for damages caused by inappropriate handling
and use of the product.
In order to reduce the injuries or damages, follow basic safety precautions applied when
using any electrical device, including the following:
1. Read the entire instruction manual before you start installation and assembly and keep it
for future reference. Keep the manual for future reference.
2. Before connecting the device to power supply socket, make sure the voltage indicated on
the device corresponds to the voltage in the power supply socket.
3. Use only the included AC charger to charge the device.
4. Do not use the included AC charger to charge other devices or batteries.
5. Do not start vacuuming if the dust bag or lter are not installed in the vacuum cleaner.
6. Appliance for household use only.
7. Do not place any objects in ventilation slots.
8. Clean this device in accordance to instructions listed in Cleaning section.
9. Turn o the device:
• if it’s not operating correctly
• if there’s an uncommon voice when using
• before disassembling the device
• before cleaning
• when not in use
10.Keep the device out of the reach of children. Do not leave children unsupervised with the
product.
11.This appliance must not be used by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they are
supervised by the person who is responsible for their safety.
12.Keep the device and charger away from heat, water, moisture, sharp, edges and any other
factor which may damage the appliance or charger cable.
13.Do not place the appliance in water or any liquid; nor handle/use it with wet or moist hands.
14.Do not point tube at people or animals.
15.Do not vacuum:
• big objects with sharp edges; it may block and damage the device;
• ne dust - e.g. plaster, cement, our, etc.,
• remnants of renovation works, debris etc.,
• harmful and corrosive liquids or ammable and explosive substances as this may cause
re;
• hot or glowing substances;
• wet or moisture surfaces and objects;
• water and other liquids.
16.Do not use the product for purposes dierent from displayed in this operating manual.
17.Do not leave the appliance unattended when it’s working.
18.Producer of this product is not responsible for damages caused by inappropriate handling
and using of the device.
18 Owner’s manual 19
EN EN
Owner’s manual
ASSEMBLING/DISASSEMBLING
CHARGING
19.Do not use this device if the charger cable is damaged or appliance is broken.
20.Do not attempt to repair this device yourself. Only authorized and qualied personnel may
repair this device. Never disassemble this device.
21.Use only authorized accessories.
Wall mount
1. The vacuum cleaner can be attached to the wall using
mounting plate.
2. The plate should be attached to the wall with mounting
pins and screws, which are included in the kit.
3. Choose a location near the power outlet (the charger cable
has a length of 1.8 m).
4. The wall mount is located at the bottom of the battery
housing.
Attaching accessories
1. To attach the accessory to the tube / hand vacuum cleaner, push its end onto the tube /
hand vacuum cleaner until it locks in place.
2. Correct installation is indicated by an audible click.
3. Appropriate cutouts at the ends of accessories do not allow you to connect them
incorrectly.
4. To disconnect the accessory, press the release button and pull it out.
1. Make sure the device is switched o.
2. Connect the AC charger plug to the device's charging socket, which is located at the back
of the battery housing next to the handle. Connect the AC charger to the power socket.
3. When the battery is fully charged, two LEDs are on.
4. When the battery is half empty, one LEDs is on.
5. When the battery level is low, the lower battery level indicator blinks until the device turns
o.
6. When the battery is completely discharged, pressing the power button will cause the
lower LED to ash for a few seconds.
7. Fully charged battery allows:
• 16 minutes usage in normal mode
• 40 minutes usage in slow mode
8. Charging takes up to 6 hours.
9. When the battery is charging, the lower battery level indicator will blink.
Bekijk gratis de handleiding van Teesa Sweeper 7000 TSA5040, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Teesa |
| Model | Sweeper 7000 TSA5040 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 4022 MB |
