Technisat Pureno Trim 100 handleiding
Handleiding
Je bekijkt pagina 40 van 124
40
WARNING
Risk of injury!
Do not aempt to repair an electrical device yourself.
In the event of defects, always contact the service department (“4.5 Service
information” on page 31).
Problem Possible cause Solution
The device only
operates slowly or does
not start.
The baery is flat. Charge the baery.
The baery is not
charging.
Lower voltage at 0-10
% and 90-100 % to
protect the baery.
Baery protective
circuit.
The suction power is
too weak.
The baery is too
weak.
Charge the baery.
The dust holder is
overfilled.
Empty the dust holder.
The filters are
contaminated.
Clean the filters.
The suction opening is
blocked.
Switch o the device
and remove the
blockage.
Particles that are too
large or heavy can
stick to the carpet.
Remove these foreign
bodies
by hand.
Dust is escaping from
the device during
vacuuming.
The dust holder or
filter are not seated
correctly.
Correct the position of
the dust holder
and filter.
Ensure that the
dust holder is closed.
The filters are
contaminated.
Clean the filters.
The filters are worn
out or damaged.
Replace the filters.
Bekijk gratis de handleiding van Technisat Pureno Trim 100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Technisat |
| Model | Pureno Trim 100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10661 MB |
