TC Electronic VoiceLive Touch handleiding

Niet gecategoriseerd

TC Electronic

42 pagina's

PDF beschikbaar

Handleiding

Mounting to a Mic Stand

MIC STAND SETUP

1. With no cables attached to the product, grasp it on both sides so

the printed top faces you and is approximately level.

2. Slide VoiceLive Touch to the left so that the upper shaft of your

mic stand is captured by the lower slot on the product. (Figure 1)

3. Slowly but firmly lower the front of the product so the serrated

slot fully captures the micstand shaft. (Figure 2) You’ll feel initial

resistance then the shaft should snap in and seat tightly.

Removal is the reverse: lift the front of the product so it snaps free of the

micstand shaft then slide right to remove.

Note that micstand diameter should not exceed 16.5 mm.

CABLING

The horizontal mounting slot on VoiceLive Touch is also used to collect

your cables. As shown in the graphic below, cables can be threaded

through the slot. Use the provided cable wrap to tie your cables neatly

to your micstand.

Bekijk gratis de handleiding van TC Electronic VoiceLive Touch, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.