Swann SWIFI-LEAK handleiding
Handleiding
Je bekijkt pagina 4 van 32
4
EN
BATTERY INSTALLATION
1 Unscrew the sensor cover with the supplied screwdriver and lift it off.
2 Insert the supplied two AAA batteries into the battery compartment according to the polarity
markings (+ and -) shown. Pairing mode will automatically activate on the sensor for 3 minutes
when batteries are inserted. The sensor status light will blink blue slowly during pairing mode.
Note: Pairing mode on the sensor can be activated at any time by re-inserting the batteries.
3 Proceed to the Swann Security app on your mobile device to pair the sensor (see next page) with
your Wi-Fi network.
4 Once the sensor has been successfully set up via the Swann Security app, screw the sensor cover
back in place.
Note: Should you need to replace the batteries in the future, there is no need to re-pair the sensor.
Simply wait for pairing mode to timeout (3 minutes), after which the sensor will automatically
reconnect to the previously congured Wi-Fi network.
Bekijk gratis de handleiding van Swann SWIFI-LEAK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Swann |
| Model | SWIFI-LEAK |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2392 MB |
