Handleiding
Je bekijkt pagina 28 van 393
28
28
Flame Output Speed Setting
After replacing the injectors, it is also necessary to adjust the gas
taps to the new type of gas.
Before starting the operation, make sure that the appliance plug is
plugged in, the gas supply is on and the burners are completely placed.
Note: Gas setting screw for the low ame position must be loos-
ened when switching from LPG to natural gas. During switching from
natural gas to LPG, it should be tightened.
1. Put the cooker burners in a low position and pull out the cooker
control knobs on the control panel (See gure 4).
2. With the help of a proper size screwdriver, tighten/loosen the
gas setting screw (See gure 5). This enables the ame in the low po-
sition to increase or decrease. Adjust the proper gas setting so that
the ame length is at least 4 mm.
3. For the nal check, turn the ames of the cooker burners to the
highest and lowest positions. In both cases, the ame must be ignited.
4. Repeat these procedures for each burner of the cooker.
5. After making the proper gas setting, install the control knobs in
order to use the product.
Figure 4 Figure 5
WARNING: Depending on the type of hob spout
used in your product, the position of the gas setting
screw may vary.
Bekijk gratis de handleiding van Svan SKGW4602, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Svan |
| Model | SKGW4602 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 30355 MB |
