Handleiding
Je bekijkt pagina 11 van 48
Placement
2.3
Before using the freezer,
please remove all the
package, which includes
the base pad, the foam
cushion block in the
freezer and adhesive
tape, etc. And tear off
the protective film on the
door body and case.
Place the freezer in a
well-ventilated indoor
area with a flat and
sturdy ground.
Select the place that is
far away from the heat
source and direct
sunlight Do not place it
in damp or watery areas
to prevent rusting or
weakening the insulation
effect.
The top space of the freezer
should be greater than 70cm
and the distance between the
sides and back of the freezer
and the wall should be greater
than 20cm, so as to facilitate the
opening and closing of the
freezer door and heat dissipation.
(The above are for reference only, and the actual configuration shall be subject to the actual purchase
or the seller's statement)
Start
2.5
Energy saving tips
2.6
The appliance should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
Let hot foods cool to room temperature before placing in the appliance. Overloading the appliance
forces the compressor to run longer. Foods that freeze too slowly may lose quality, or spoil.
Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance. This
cuts down on frost build-up inside the appliance.
Appliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling. Liners
interfere with cold air circulation, making the appliance less efficient.
Organize and label food to reduce door openings and extended searches. Remove as
many items as needed at one time, and close the door as soon as possible.
Changing the light (optional)
2.4
The LED light must be replaced by a professional from the manufacturer, its maintenance
department or other similar departments.
(The above are for reference only, and the actual configuration shall be subject to the actual purchase
or the seller's statement)
After opening, the freezer is as
shown in the figure. Next, take
out the power line from the hole;
Taking a tool (flat screwdriver or cone),
insert it into the gap at the arrow
position in the figure and gently pry it
outward to open the flip.
After removing the power line,
cover the cover plate again.
After transportation, please let the freezer stand for at least 2 hours before
connecting to the power supply, otherwise it may cause performance
degradation or damage to the freezer.
Before storing fresh or frozen food in the freezer, run the freezer for 2 to
3 hours; in hot summer days, users should run the freezer for 4 hours in
advance.
During the power cut or cleaning, users should pull the plug off and plug in
again after a 5-minute interval in case the continuous start damage the
compressor.
EN-9
Bekijk gratis de handleiding van Svan SCH1002EDC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Svan |
| Model | SCH1002EDC |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 3674 MB |
