SurgeX enVision handleiding
Handleiding
Je bekijkt pagina 25 van 34
User Manual
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / ametekesp.com 24
Twelve types of events are logged:
▪ Overload: Load current draw has exceeded 25A
▪ Surge: enVision has been exposed to a transient voltage in one
of the 3 possible modes (between Live and Neutral, between
Live and Ground, between Neutral and Ground) with a peak
amplitude of 500V* or higher and a frequency of 20 kHz or
higher. *500V surge voltage amplitude applies to IEEE C62.41
Category B Impulse; surge voltage amplitudes necessary for
detection of other surge types may vary.
▪ Over Voltage (Cutoff): Line voltage exceeded the over voltage
shutdown threshold, and connected equipment was turned off.
▪ Over Voltage (Record): Line voltage exceeded the over voltage
record threshold, and connected equipment was not turned off.
▪ Under Voltage (Record): Line voltage dropped below the under
voltage record threshold, and connected equipment was not
turned off.
▪ Under Voltage (Cutoff): Line voltage dropped below the under
voltage shutdown threshold, and connected equipment was
turned off.
▪ Power Outage: Loss of AC power.
▪ Turn On: The enVision outlets were turned on.
▪ Turn Off (Cycle): A power cycle was initiated by a
received command.
▪ Turn Off (Software): Outlets were turned off by a received
command.
▪ Turn Off (Button): Outlets were turned off by the
pushbuttons.
▪ Turn Off (Loss of Ground): Outlets were turned off due to the
loss of the safety ground conductor at the wall receptacle.
Bekijk gratis de handleiding van SurgeX enVision, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | SurgeX |
| Model | enVision |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7278 MB |
