Supermicro SuperServer AS-3015MR-H10TNR handleiding

Niet gecategoriseerd

Supermicro

94 pagina's

PDF beschikbaar

Handleiding

Chapter 7: Troubleshooting and Support

7.4 BIOS Error Beep (POST) Codes

During the POST (Power-On Self-Test) routines, which are performed each time the system

is powered on, errors may occur.

Non-fatal errors are those which, in most cases, allow the system to continue the boot-up

process. The error messages normally appear on the screen.

Fatal errors are those which will not allow the system to continue the boot-up procedure. If

a fatal error occurs, you should consult with your system manufacturer for possible repairs.

These fatal errors are usually communicated through a series of audible beeps. The table

below lists some common errors and their corresponding beep codes encountered by users.

BIOS Error Beep (POST) Codes

Beep Code Error Message Description

1 short Refresh Circuits have been reset (Ready to power up)

5 short, 1 long Memory error No memory detected in system

5 long, 2 short Display memory read/write error Video adapter missing or with faulty memory

1 long continuous System OH System overheat condition

Additional BIOS POST Codes

The AMI BIOS supplies additional checkpoint codes, which are documented online at http://

www.supermicro.com/support/manuals/ ("AMI BIOS POST Codes User's Guide").

When BIOS performs the Power On Self Test, it writes checkpoint codes to I/O port 0080h.

If the computer cannot complete the boot process, a diagnostic card can be attached to the

computer to read I/O port 0080h (Supermicro p/n AOC-LPC80-20).

For information on AMI updates, please refer to http://www.ami.com/products/.

Bekijk gratis de handleiding van Supermicro SuperServer AS-3015MR-H10TNR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.