Supermicro A4SAN-E handleiding
Handleiding
Je bekijkt pagina 39 van 135
2.4 Battery Removal and Installation
Battery Removal
To remove the battery, follow the steps below:
1. Power off your system and unplug your power cable.
2. Remove the battery cable at the BT1 connector on the board.
3. Remove the battery.
Proper Battery Disposal
Warning! Handle used batteries carefully. Do not damage the battery in any way; a
damaged battery may release hazardous materials into the environment. Do not
discard a used battery in the garbage or a public landfill. Comply with the regulations
set up by your local hazardous waste management agency to dispose of your used
battery properly.
Battery Installation
To install the battery, follow steps 1 and 2 above and continue below:
1. Connect the battery cable into the battery connector (BT1) and push it down until you
hear a click to ensure that the cable is securely locked.
2. Use the foam tape on the back side of the battery to secure it to a flat surface on the
bottom of the motherboard or a proper location in the system. Do not place the battery on
39
A4SAN-H/-E/-L/-WOHS: Component Installation
Bekijk gratis de handleiding van Supermicro A4SAN-E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Supermicro |
| Model | A4SAN-E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15888 MB |
