Handleiding
Je bekijkt pagina 56 van 68
56
After initial installation, servicing, or changing gas cylinders etc., the gas pipes may contain
some air which should be allowed to escape by briefly turning on the refrigerator. This will
ensure that the flame lights immediately.
1. Make sure that all valves between the gas container and the refrigerator are open.
2. Depress the safety device control (C) and hold it down while depressing the Pulse
ignition switch (A).
3. Check the flame indicator (B) to see whether the flame is alight.
4. Keep the safety device control (C) depressed for a further 10-15 seconds.
5. Release the safety device control (C) and again check to see that the flame is alight.
To terminate gas operation, turn off the gas valve from the gas container.
Replace the battery for electronic spark ignition
When the battery ignition fails to spark, you need to replace the battery, replacement step
as follows
1. Hold and pull down the “A” as illustrated in pic, take out the battery box.
2. Replace the old battery with new one. Note: 7#1.5V battery need to be used and
the red wire must connect to the “+” side of the battery.
Regulating the temperature
The position number refers to fig. 1.
It will take several hours for the refrigerator to reach
normal operating temperature. The temperature of
the main compartment of the refrigerator is controlled
by a thermostat. The thermostat knob (D) should be
set at lower to MAX. If a lower (colder) temperature is
desired, set the thermostat to a wide mark.
Please note that too much lower temperature might make
vegetable or egg frozen.
ENG
ENG
Bekijk gratis de handleiding van Sunwind Ventus 225, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sunwind |
| Model | Ventus 225 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 4971 MB |