Sun Joe 24V-HCS-4-LTE handleiding
Handleiding
Je bekijkt pagina 11 van 24
11
Adjusting the Chain Tension
mWARNING! Use protective gloves when handling the bar
and chain.
1. Make sure the pruning saw is shut off and the battery is
removed. Loosen the chain/sprocket end cover a little by
turning the end cover knob counterclockwise (Fig. 3).
2. Use the equipped hex key wrench to turn the chain adjusting
screw clockwise to tighten; turn it counterclockwise to
loosen. A cold chain will be correctly tensioned when there
is no slack on the underside of the guide bar; the chain is
snug, but it can be turned by hand without binding (Fig. 4).
NOTE: When not in use, the hex key wrench can be stored
in the hex key wrench slot located on the bottom of the
pruning saw (Fig. 5).
R
Fig. 3
Chain/sprocket
end cover
End cover knob
Fig. 4
Chain adjusting screw
Fig. 5
Hex key wrench
Hex key wrench slot
3. Retighten the end cover knob. Using a screwdriver, run the
chain along the guide bar to check that it moves smoothly.
Chain Lubricant
IMPORTANT! Only use a good quality bar and chain oil
designed specifically for use with chain saws to ensure optimal
lubrication of the cutting parts. Do not use oil containing
impurities.
IMPORTANT! The chain lubricating oil is bio-degradable. The
use of mineral oil or engine oil can have a serious impact on
the environment. It is essential that you use good quality oil to
lubricate the cutting parts effectively. Used or poor quality oil
does not guarantee good lubrication and reduces the lifespan of
the chain and bar.
Before lubricating the pruning saw, clean the guide bar and
saw chain with a soft brush. Clean oil inlet with top of oil bottle
to ensure the oil inlet is not blocked by chips. Then drop the oil
into oil inlet (Fig. 6). Or drop the oil between the chain and the
bar. Insert the battery and switch on the pruning saw. The oil will
be evenly distributed over the chain. For optimal cutting result,
lubricate the saw every 30 minutes during operation. When
storing the unit for a long period of time (3 months or longer), be
sure the chain is lightly lubricated; this will prevent rust on the
chain and bar sprocket.
Operation
Starting and Stopping
mCAUTION! Starting, stopping, and restarting an electric
motor repeatedly within a few seconds can generate a great
deal of heat and damage the motor. To protect the life of your
cordless pruning saw, always wait at least five seconds after
stopping before restarting the saw.
mWARNING! Be sure that the chain is not in contact with
any object when you start the motor.
mWARNING! Keep hands away from chain. Keep hand on
handle. Do not overreach.
Fig. 6
Bekijk gratis de handleiding van Sun Joe 24V-HCS-4-LTE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sun Joe |
| Model | 24V-HCS-4-LTE |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3029 MB |
