Structural Concepts Reveal NR4833DSSV handleiding

Niet gecategoriseerd

Structural Concepts

21 pagina's

PDF beschikbaar

Handleiding

CLEANING SCHEDULE (TO BE PERFORMED BY STORE PERSONNEL)

FREQUENCY INSTRUCTIONS

Daily Glass Surfaces: Clean side glass and shelves with household or commercial glass

cleaner.

Daily Rear Sliding Door Exterior Glass: Clean with household or commercial glass cleaner.

Clean out rear door track with moist cloth.

Daily End Panels, Front Panel, Toe-Kick, etc.: Wipe off all surfaces with warm water and

mild soap solution and non-abrasive cloth.

Daily Decks: Wipe off decks with moist cloth dipped in mild soap and water solution.

Daily Acrylic Surfaces (Sneeze Guard / Optional Acrylic Security Cover):

• Clean: Use soft, clean cloth dipped in solution of warm water and small amount of

mild, liquid soap. Apply light pressure while wiping away all smudges and residue.

• Rinse: Use pure water in spray bottle to rinse.

• Dry: Use soft, clean cloth (rather than abrasive paper towel).

• Avoid: Never use window or household cleaners such as Windex®, Formula 409®,

or fantastik®. Never use scouring compounds or solvents such as acetone, gasoline,

alcohol, 111 trichloroethylene, WD-40® or lacquer thinner.

• Polishing: Buff with light coat of automobile paste wax or plastic cleaner/polish.

• Scratches: Use high quality buffing compound. Carefully follow instructions.

Daily Stainless Steel Surfaces:

• Wash with a solution of hand dishwashing liquid detergent and water, or a solution of

baking soda and water. Rinse and polish dry with paper towel or soft cloth.

• Never use scouring powders or steel wool as they will scratch stainless steel.

• Brighten by polishing with a cloth dipped in vinegar or in ammonia; sprinkle baking

soda on sponge and rub gently; rinse. Polish dry with paper towel.

• Remove streaks or heat stains from stainless steel by rubbing with club soda.

Quarterly Under Case Cleaning:

A. Rolling Case To New Location:

• If case is NOT hard wired, it may be rolled forward or backward to allow access to

case underside (depending upon its store placement).

• Use vacuum with brush extension or broom and dust pan to remove all dust, dirt,

food particles or residue.

• Roll case back into its previous location after cleaning is complete.

B. Case Component Removal:

• Whether case is hard wired or not, case components may be removed to allow

cleaning under case.

• Case components are held in place with magnets and are removable without tools.

• Remove side cladding, front panel, front toe-kick or lower rear panel by lifting up and

off case. See INSTALLATION, CONT’D: ATTACH COMPONENTS (FRONT &

REAR PANELS, CLADDING, ETC.) section in manual for illustrations.

• Use vacuum with brush extension to remove all dust, dirt, food particles or residue at

underside of case.

• Replace components when cleaning process is complete.

Bekijk gratis de handleiding van Structural Concepts Reveal NR4833DSSV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.