Structural Concepts Reveal NR3635DSV handleiding

Niet gecategoriseerd

Structural Concepts

15 pagina's

PDF beschikbaar

Handleiding

4. Place Decks Inside Case

• Remove decks from bubble-wrap; place in case.

• See illustration below.

5. Remove Glass From Bubble-Wrap and

Place On Shelving Bracketry

• Remove glass (for shelves) from its bubble-wrap.

Place them on shelving bracketry.

• Caution! Glass pieces ARE NOT IDENTICAL!

Notches on underside metal covers determine

placement in case (as illustrated below).

• See next page for complete illustrative breakdown

of shelving bracketry and glass shelving pieces.

6. Plug Case Into Approved Outlet

• Plug is located at case rear.

• Plug case into approved outlet.

• Case will energize.

7. Turn On Light Switch

• Switch location shown in illustration at right.

• LED lights should immediately come on.

INSTALLATION, CONT’D: COMPONENT PLACEMENT / PLUG / LIGHTS / COUNTER ATTACHMENT

• If LED lights do not immediately illuminate, see

TROUBLESHOOTING section in this manual.

8. Sealing Unit To Counter

• Thoroughly clean counter and underside of base.

• Seal unit to countertop with silicone that meets or

exceeds food grade NSF/ANSI Standard 51:

• Apply thin, UNINTERRUPTED bead of silicone

sealant along lower edge of case to prevent

accumulation of dust, residue and liquids as well

to prevent insect harborage.

9. Attaching Unit To Counter With Lag Bolts

• Earthquake Hazard Zones: Case may ALSO

be bolted to counter with lag bolts (or other

secure fasteners).

• Caution! Only trained service providers

should perform such attachment procedures.

• If code requirements allow, the SAME lag bolts

that held case’s support base to pallet may also

be used to secure case to counter.

• See previous page for illustrations.

--- Model NR4835DSV ---

Bekijk gratis de handleiding van Structural Concepts Reveal NR3635DSV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.