Structural Concepts Fusion GMSV6H handleiding

Niet gecategoriseerd

Structural Concepts

20 pagina's

PDF beschikbaar

Handleiding

START-UP / LIGHTING / CASE TEMPERATURE / PROGRAMMABLE CONTROLLERS / OPERATION

1. Merchandiser Start-Up

• Case must be field wired.

• When power is supplied, throw main power

switch at case rear-right and case will power-up.

• See illustration below-right.

2. Lighting

• Overhead ceramic metal halide light switch is

at case rear, right side.

• See illustration below-right.

3. Case Temperature

• Well temperature is dependent upon both the

waterless well temperature and the overhead

ceramic heater temperatures.

• Preheat case to 170 °F on case temperature

dial (photo shown below-left) before placing

food into case.

• Caution: Case Temperature dial reflects internal

case temperature ONLY (not product temperature).

Use a food probe to determine ACTUAL product

temperature!

4. Product Heating Guidelines / Programmable

Controllers Information

• Well and overhead ceramic heaters are controlled by

Programmable Controllers.

• These controllers are located on rear wireway cover

(as shown in illustration below-right).

• Programmable controllers are pre-set at the factory to

heat both overhead and well at proper temperatures.

Modifications to these settings should be rare.

• Should programmable controllers need to be revised,

see PROGRAMMABLE CONTROLLER section in

this User Manual for additional information.

Case

Temperature

Dial

Bekijk gratis de handleiding van Structural Concepts Fusion GMSV6H, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.