Structural Concepts Fusion GMS8H handleiding
Handleiding
Je bekijkt pagina 12 van 19

1. Raise the Curved Glass
• To raise the front glass, secure
the lift handle extrusion on the
bottom edge of the door and
lift up. Gas cylinders hold the
glass open for hands-free
access to case interior.
• Caution: Gently return curved
glass to original
position.
• See illustration at right.
2. Removing the Rear Doors
Note: Doors are not interchangeable. There is
an inner and outer door. The outer must be
removed first and replaced last.
• The outer door, is the right hand door (from
the service side or rear of the case). It can
be identified by a stop located at the lower
right hand corner to the inside of the case.
• Move the doors toward the center of the
case.
• Individually lift each door up toward the top
of the case and pivot bottom of the door out.
• Reverse to install.
• See illustration at right.
• Caution: Gently set doors down to avoid
marring, scraping, scratching or breakage.
3. Rear Ledge Removal Steps
Rear ledge is connected to shelf track.
Illustrations at right reflect step-by-step
removal method (as enumerated below).
1. Hinged support bracket is shown in
its standard upright position.
2 & 3. While upright, Rear Ledge must be
slid away from case and then rotated downward
to vertical position.
3 & 4. From the shelf’s lowered position, lift
from bottom edge upward to disengage shelf
track (and attached Rear Ledge) from bracket.
12
FRONT CURVED GLASS / REAR DOORS / OPTIONAL REAR LEDGE
View of Rear
Doors being
lifted up,
pivoted out and
away from
case.
Rear
Ledge
Hinged
Support
Bracket
Shelf
Track
Hinged
Support
Bracket
-1- -2- -3- -4-
Shelf
Track
————— Rear Ledge Removal Steps —————
Note: For clarity, only Shelf Track is shown being
removed. Rear Ledge is attached to Shelf Track.
View of Curved
Glass Being Raised
Bekijk gratis de handleiding van Structural Concepts Fusion GMS8H, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Structural Concepts |
Model | Fusion GMS8H |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 8329 MB |