Structural Concepts Fusion GMGV4 handleiding

Niet gecategoriseerd

Structural Concepts

43 pagina's

PDF beschikbaar

Handleiding

TROUBLESHOOTING - GENERAL ISSUES (PAGE 1 of 3)

CONDITION TROUBLESHOOTING

Case Not Lining Up Cases must be level and plumb. See INSTALLATION: FRAME

SUPPORT RAIL SHIMMING section in this manual for instructions on

properly aligning case (alongside other cases) and shimming rails.

Water Is On The Floor Caution! Water on flooring can cause much damage! Until cause is

determined (and repaired), following these procedures:

• Use wet-dry vacuum (or mop & bucket) to remove standing water.

• Use ‘catch pans’ for water to drain into. Swap out regularly until case

has completely drained.

• Contact Structural Concepts Technical Service. See telephone

number on final page in this manual.

Check that the drain trap is free of debris.

Check that the drain hose is correctly connected to drain piping to floor

drain.

Check store conditions.

• To prevent condensation in NSF/ANSI Type I environments, maximum

conditions are to be 55% relative humidity / 75° Fahrenheit.

• For NSF/ANSI Type II environments, maximum conditions are to be

55% relative humidity / 80° Fahrenheit.

• If you are unsure if your unit is classified as NSF/ANSI Type I or Type

II, see tag next to serial label on your case.

Bekijk gratis de handleiding van Structural Concepts Fusion GMGV4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.